Jump to content

Klackinon

Members
  • Content Count

    8
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Klackinon

  • Rank
    1st Gear
  • Birthday 03/08/1985

Contact Methods

  • MSN
    klackinon@yahoo.com

Profile Information

  • Gender
    Male

Previous Fields

  • Location
    Christchurch
  • Car
    1991 325i SE
  1. hey my car is on 18" mags and sits at 110mm at its lowest point, and i have been told recently that one of the springs is no longer captive, i was just wondering if rubbing may be caused by the springs compressing further? as far as im aware the tyres never used to rub would getting springs thaqt arent as low fix the problem? cheers
  2. they are standard height as far as i am aware, i dont have them - my boss put lowering springs in his m3 so he has his old ones spare now, if you wanted to buy them off him i could get you in contact if you like? thanks for the advice
  3. hey guys im in need of some new springs for my e36 325 sedan and have sourced a set of second hand good condition e46 m3 springs, i was wondering if anyonhe knows whether or not these are compatibile with my car? thanks
  4. after next pay check i am definitely getting alignment done lol. not sure what brand tryres they had on when it was wearing really badly, i know i have bought cheapies since then thanks for measurements 3pedals !! and all other advice cheers you guys are awesome
  5. thanks for advice yes it is lowered on aftermarket 18" mags, the last guy who owned the car had it done so what would be the best solution? raise it on new springs? would rather fix it permanently than go through heaps of tyres what height are m3's at? im not really that attached to having it super low edit: have not measured it but i had another look and it seems to be on a similar angle at all four tyres yet it looks as though he only lowered the back ? >> http://www.bimmersport.co.nz/forums/index....st&id=11435
  6. hi guys i recently had to replace all four of my tyres as they were wearing very unevenly, the outside of them was fine but the inside tread completely gone i had a look and they are on a lean coming further away from the car at the bottom, is this a suspension issue or would a wheel alignment fix it? any help would be appreciated thanks
  7. yeah you would be right imported in 95 im the third owner in nz not sure about the piping but im sure i have seen the white leather on another bmw on trademe
  8. hi everyone i bought my beamer a few weeks ago its a 1991 325i se, manual have only owned various hondas before this, am completely in love with it eh, have never just wanted to go for drives for no reason before now awesome car completely different feeling to jap cars, planning to spend some money fixing it up a bit but have to say dont think i could make it look too much nicer anyway hi again
×
×
  • Create New...