drpotato 0 Report post Posted January 29, 2013 Hi guys, I recently changed the seats in my E36 325i from some old ripped up ones to some nice, clean M-sport seats. The problem I have had since then is the airbag light comes on when the start is first switched on, and stays there for a couple of minutes. Fortunately I haven't had to get a warrant since I changed the seats, but I assume this would make it fail. Anyway - my mechanic ran a diagnostic on the ECU, and found that it was the airbag sensor not getting any power - this makes sense, because I have left the wires unplugged - the car seems to have a different connector to the seats I have put in there! The car seems to have a 3-pin connector (white/red, purple/white, brown), whereas the seats only have blue and white. Question is - what should I connect to what in order to get rid of the airbag light? I'm comfortable splicing wires, so no issues there. Cheers Quote Share this post Link to post Share on other sites
BM WORLD 1258 Report post Posted January 29, 2013 you are missing the black box that goes in between the 2 plugs , i have these in stock if needed. cheers brent BM WORLD LTD Quote Share this post Link to post Share on other sites
