Sign in to follow this  
Followers 0
Ahmedsinc

Chip flash

6 posts in this topic

Is there anyone around that has the ability to flash a 413 chip with S50B32 data?

Have found a thread on an overseas forum where the OP ran an M54B30 on a red label 413 DME with a Turner / Dinan or similar chip to sort out the fuel etc tables. From what I've seen so far all the aftermarket stuff raises rev limit etc which I don't want.

Any insight would be greatly appreciated!

Edited by Ahmedsinc

Share this post


Link to post
Share on other sites

Am I asking a taboo question? Or is this one in the too hard basket? :blink:

Share this post


Link to post
Share on other sites

Not keeping the siemens ecu?

Share this post


Link to post
Share on other sites

Not keeping the siemens ecu?

Using M50 intake and single vanos so no point. Keeping everything just in case I change my mind.

Probably a stupid question, but I don't suppose the Siemens chip would fit the Bosch board?

Share this post


Link to post
Share on other sites

Using M50 intake and single vanos so no point. Keeping everything just in case I change my mind.

Probably a stupid question, but I don't suppose the Siemens chip would fit the Bosch board?

Not at all.

I have done 402/405/413 stuff, but my burner has crapped out / playing up.

Share this post


Link to post
Share on other sites

Not at all.

I have done 402/405/413 stuff, but my burner has crapped out / playing up.

Killer. Will send a PM tomorrow

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0