Jump to content
Sign in to follow this  
_Matt_

Wanted: Crank Position / Speed Sensor for M30 *Urgent*

Recommended Posts

anyone out there have one or two of these lying around? I believe it's what is stopping my E28 from starting since one doesnt pass the resistence test. I'm moving house in a week so it's rather bad timing.

Anyone got some working ones? dont care if they are bad condition, I'm buying new ones anyway, I just need to be able to drive it to my new place.

TIA

Share this post


Link to post
Share on other sites

swap the 2 around (at both ends) , car will run on the one sensor , the main one is the one that works on the small trigger mark on the flywheel ,

the other runs on the flywheel teeth , but not that important to make it run ,

I take it ,its the factory e28 535i motronic setup? not converted to a e34 type setup?

Share this post


Link to post
Share on other sites

yep, factory setup.

out of a 635i I believe. Swapped them with no luck.

I'm only getting one correct resistance from point 1 to 2 of a single sensor, 1060ish ohms. Every other point on both sensors fail to read anything. The other points are suppose to shoot up to 100 000+ right?

Share this post


Link to post
Share on other sites

did you swap at the gearbox and at the top where the plugs are

Share this post


Link to post
Share on other sites

I swapped the sensor positions and also tried turning the engine over with the plugs both ways around.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...