Jump to content
Sign in to follow this  
Ahmedsinc

M52 swap EWS issues

Recommended Posts

Has anyone here successfully swapped an M52 into an E36? Have installed a B28 loom, DME & EWS into the project B30 E36 (94 325i) but while it cranks it won't start. Have plugged INPA in and it comes back with fault 18 - EWS signal. As the loom & DME are being used in a pre EWS car I have only connected the bare basics on the EWS module: 

1 --N/C
2 --N/C
3 --N/C
4 green to DME (through X20 pin7)
5 red/ yellow to switched 12V 
6 --N/C
7 brown to ground
12 --N/C
13 --N/C
12 -- N/C
14 -- N/C

 

I have the transmitter sharing switched +12v with the EWS, some guides say to supply the unit with constant +12v? Also, as the transmitter unit came without plugs I initially had the signal & power wires backward but this has now been fixed. 

 

Failing an obvious solution, is anyone here able to delete EWS from an MS41 DME?

 

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...