MrE36325i

If there is a next time you should check out http://www.bavauto.com/shop.asp Ive have great sucess .

The only way this system works is cause people pay the fines ,Deny the speed and go to court, defend yourself. If everyone did this the cost to prosecute would out way the fine and bingo

You had a miss type what you meant was This is a bad thing!

They owe me 900 but I could let them go for $500

The Getaway 2013 they killed so many E36s

But you read it so I hope its valid to you

E36 There is an issue with the wiring loon running to the boot lid the constant rubbing due to opening and closing wears through the wires and has the potential to be costly,It might pay to get your checked And Ive found out that the oxygen sensor is by passed by the ECU till the car is warn, So if you have a fault when the is cold or hot I wouldnt replace this first, thank you Idle control valve

Hi This part is not on my car as standard so not there sweet As for the headers had them custom made ,I have got as a wall hanging, a set of second hand supersprint SS headers, I was told from the seller they would fit a right hand drive, and they would if I didnt need to steer

this is the replacement for mine it looks to me the cats are there mine looks identical

Fidanza 13 lbs what is the model of your E36? the beauty of bolt on bits motors are cheap

The old boy was build up for the european market ,I assume it has cats But i cant find what a catless system looks like any ideas? as per the vin code it usually says catless Clutches are easy and when I say easy the mechanism is simple like a kit RC , the hardest part to install is the starter motor bolts but thats another story

Schrick High Performance Camshaft - 252 Degrees - Intake Camshaft $749 Schrick High Performance Camshaft - 244 Degrees -Exhaust Camshaft $ 749.95 US dollars but what the hell 6 cyliders love to sing You know you want to

I thought there also should be an increase ,But with clutch drag thats serious and easy to pick up ,I have a very clear friction point. There is the fact that the old boys rev range needs a chip get my drift

headers done ,Supersprint backbox , but the cats and pre muflers still remain but as for the cost the dual mass flywheel had lost its spring and to replace that I got a quote $2000 nzd ,so went shopping off shore and picked up m3 clutch kit with alloy flywheel with new bolts for $800 usd and did it myself + replaced the main engine rear seal while I was in there

Its less than half the weight