ahmedc
-
Content Count
13 -
Joined
-
Last visited
Posts posted by ahmedc
-
-
1 hour ago, Mad_Max said:I believe there are two different sizes, depending on the input shaft diameter, so it depends on if your input shaft is 12mm or 15mm. The outer diameter is the same, and the thickness doesn't matter too much. Just measure the input shaft diameter of the gearbox you are using and order the bearing to suit that.
Make sure you get the bearing installed at the correct depth too.
Sweet, thanks for that. Will measure it once I get it but I'm looking at a getrag 240 so can have a look online as to what the measurements are for that.
-
Hi guys,
I've got a 1989 318i M40B18 and I'm looking to get a new pilot bearing as I'm planning a manual swap. Does anyone know what dimensions I need for the pilot bearing to fit my engine?
So far having a look online I'm to believe that the dimensions are as follows for the pilot bearing:
Width [mm] 9 mm
Inner diameter [mm] 15 mm
Outer diameter [mm] 32 mmIf that was the case then would a 10mm width x 15mm inner diameter x 32 mm outer diameter make much of a difference?
-
On 3/31/2020 at 2:13 PM, modz said:Cheaper to buy one ex UK. About $100NZD landed.
Do you know any other website other than Ebay that I can look for parts that has shipping?
-
Hi Guys,
Was wondering whether anyone here has a manual pedal assembly that they want to get rid of/sell. I'll be happy to buy it, given the price and condition are good. Doesn't have to come with the clutch master cylinder but would be preferred if it does.
Thanks.
-
Hi Guys,
Anyone have one of these for sale or know where I can them within NZ? Its for the radiator fan on my 318i 1989. It's located in the front of the car, just in front of the radiator fan as below:
My one currently doesn't set the low fan speed, only high and that too when I jump the wires. Looking online it says that if you jump the fan and it only works on high, then it's a faulty resistor.
Thanks.
- 1
-
On 1/30/2020 at 7:23 AM, BM WORLD said:$100
Cheers mate, I'll let you know if I decide to but I can't confirm anything.
-
On 1/26/2020 at 8:33 AM, BM WORLD said:no i mean buy this seat and swap the squabs over to your driver seat frame
How much will you be able to sell the seat for?
-
Hi All,
Has anyone successfully attempted an auto to manual swap for an e30 318i 1989? If one was to attempt this, what sort of compatibility do I need? do I need an exact 1-to-1 car e.g. 318i and a donor 318i? can I use an earlier model manual? Would like to know what goes into it.
Thanks.
- 1
-
8 hours ago, BM WORLD said:no i mean buy this seat and swap the squabs over to your driver seat frame
What about the seat adjust handles? aren't those stuck to the seat itself or is it stuck to the frame of the seat? If they are stuck to the seat itself then can't really use the left for the right since the handles will get in the way.
- 1
-
-
Hi Guys,
Recently bought a 318i but the front seat (driver side) seems to be peeling off/torn. Wondering whether anyone has a good place to get the whole seat and not just the cover. Used is preferred so long its in good condition, wouldn't mind new either? Any suggestions?
Thanks.
-
Pilot Bearing for an E30
in Performance
Posted · Report reply
Confirmed with Brent. Thanks a lot guys. He said the dimensions are fine.