Replacing inlet manifold gasket/s, Pics.

[doughnut 0]

Hey guys,

I'm halfway through this project atm though thought I'd post a new topic for those that are interested.

Story :

Had a bad vaccum leak on the 5th inlet, which was so loud that people were actually commenting on it, "whats that noise!" etc. Its been around 3 weeks of driving around on 5 1/2 cylinders and the eratic idle is killing me.

pulling the inlet manifold was a snatch, I didn't pull off the injector rail, nor the throttle body (didn't see the need) Getting hoses and wiring out of the way was the hard part, finaly ended up getting him off, gaskets were all slightly cracked and the 5th cylinder gasket was in two pieces :

thinking about doing the injector 'o' rings, curious though are they a special 'o' ring as in are they shaped, or are they just normal rubber rings, if so, what size are they?

Peace.