DRTDVL 0 Report post Posted December 22, 2009 Just wondering if you could reshape/flatten parts of it by using a heat gun? Quote Share this post Link to post Share on other sites
Nobimmer 694 Report post Posted December 23, 2009 i have one sitting here doing nothing if you wanna come try it. Quote Share this post Link to post Share on other sites
DRTDVL 0 Report post Posted December 23, 2009 I got one from james, it fits for what i want it for but it's not flat along the top. i was wondering if a heat gun could be used to heat and then flatten the top part to match the flat edge of the 205 bumper... the curve basically matches it's just not top edge flat. Quote Share this post Link to post Share on other sites
CamB 48 Report post Posted December 23, 2009 Do you have some snow to plow? LOL. Quote Share this post Link to post Share on other sites
e30plz 1 Report post Posted December 23, 2009 Might melt it and deform it a bit, why not cut the top to make it flat? Quote Share this post Link to post Share on other sites
DRTDVL 0 Report post Posted December 23, 2009 Cam we where looking at that last night and yup it's going to need a trim from the bottom to make it not draggin on the ground but damm it looks good... E30ONP - nah i can't do that as i need the top flat edge to mount the lip to the 205 bumper... Quote Share this post Link to post Share on other sites
