f.g. 0 Report post Posted October 23, 2010 seem to not want to idle correctly when it gets to tempature... otherwise idles fine... right up untill it gets to twmp then it starts doing the loop errrrr( noise climbs until about 1200 RPM) then drops like itts going to die and climbs back up from 500-700 range... errrrrr ahh errrrr ahh errrr ah errrr ah over and over and over..... but only AT operationg temp... I did some tests let me know what you guys think and we can go from there..... THANKS!! F.G. Quote Share this post Link to post Share on other sites
gouba 0 Report post Posted October 23, 2010 Check vacuum lines for leaks, clean/replace ICV and check and go from there Quote Share this post Link to post Share on other sites
f.g. 0 Report post Posted October 26, 2010 cleaning the ICV is what caused this to start happening in the first place... no vacuum leaks (tested with smoke machine) and like i said it's only when it gets hot.... any other ideas... I'm going to see if I can borrow someones I know and see if that is the problem.... Quote Share this post Link to post Share on other sites
gouba 0 Report post Posted October 27, 2010 How/what did you clean the icv with? Quote Share this post Link to post Share on other sites
f.g. 0 Report post Posted October 28, 2010 How/what did you clean the icv with? usually with denatured alcohol but this time with something called b-12 chem tool it is much like sea foam.... Quote Share this post Link to post Share on other sites
gmccormack 0 Report post Posted October 29, 2010 How does it idle when the ICV has it's wiring disconnected?? Also check for play in the throttle body shaft Quote Share this post Link to post Share on other sites
f.g. 0 Report post Posted November 4, 2010 it idles much the same but with quicker more exageated loops.... again it only gets goofy when its hot, I will check for throttle body wackness and report. Thanks again! Quote Share this post Link to post Share on other sites
