Dingo

I'm looking for a cylinder head to fit face lift 325i with M20B25 engine, 885 stamping.

I'm located in chch and would prefer to get one locally but am will organise freight if required.

I travel to Dunedin reasonably often so can pick up from there or anywhere in between.

Your spot on hybrid. I adjusted the tie rods out 2 turns each and after that the handling was much better. I was confident enough to drive to the wheel alignment place then. It was still out a fair amount by a fair amount which meant I was getting a bit of bump steer but the handling was predictable at least.

Now after an alignment it is sweet as.

Clearance between the steering linkage and the exhaust is concerning though on the lower part of the universal joint which attaches to the steering gear. It just clears when cold but was rubbing slightly after sitting in traffic on the way home. Might have to take a dremel to the joint.

I just completed swapping out the e30 steering rack for a e36 rack. Have taken it for a quick test drive and the car feels almost scary to drive. Any slight turn of the steering wheel makes the car want to steer off the road.

I'm not sure if this would be fixed with wheel alignment (which I have booked for tomorrow) or if there is some problem with the rack that makes it over sensitive. Maybe I connected the control lines the wrong way after I bent the pipes which is unlikely but possible.

I also replaced the shocks with monroe gas shocks from Euro Italian. Is it possible that there is a difference in length of the shock that would affect the handling in this way?

PM'd

PS i'm keen on the pair

Is the ECU for sale? What condition is the rubber elbow in? Would be keen on both of those.

Hey I'm quite keen on the complete car. Wouldn't be able to take it away for a couple of weeks tho as I'm in Gisborne. Is there any rust/dents in the rear doors? Does it have a standard exhaust manifold? Is it currently driveable? WOF/Reg?

Hello

I may be blind but is the gearbox auto or manual? If Auto what condition is the clutch in and are other parts for manual conversion available? Why are you selling?

How much would freight to gisborne cost roughly?

I would be keen but is it worth the freight to Gisborne?

Hi I would be keen on a few things

The main trim panel under the dash on drivers side inluding the plastic fasteners

Small triangular trim on drivers door

Dash mat

Glovebox latch

Trim that surrounds the interior door handles from all 4 doors depending on colour. Black?

Hazard lights switch

Cheers

Still in packet. Contains all required gaskets and oil seals for the m20 engine bottom end. Complete except for rear end crank oil seal.

can post more details and photos later.

offers

0211565275

still in box, never been used

comes with paper gasket but it is a little bent

offers

0211565275

I'm leaving the country so its time to sell up.

Details are

1988 2.5L 5spd manual, 4 door saloon, white. 222000km

Blue leather interior, Sony MP3 CD player, all electrics, sunroof, cruise control

Prof lowered ~30mm, factory alloys

Mechanics are running well. Strong motor and gearbox.

Interior is in good condition.

Body has small amount of rust

Minor accident damage to front left panel and bumper cover.

No current Wof or Reg as I don't have time to fix before leaving the country.

Sold