Forrest 35 Report post Posted November 25, 2008 Swapping my trailing arms, control arms and diff mount bushes with urethane on my project car. Anyone got any tips or tricks to getting them out? Or do I cut them/burn them Any help is appreciated. Cheers, Nathan Quote Share this post Link to post Share on other sites
Silver Fox 43 Report post Posted November 25, 2008 pressed all mine out with a cheap press, easy. Quote Share this post Link to post Share on other sites
Forrest 35 Report post Posted November 25, 2008 pressed all mine out with a cheap press, easy. Where can you get them from? Quote Share this post Link to post Share on other sites
Silver Fox 43 Report post Posted November 25, 2008 Paid about $90 from supercheap from memory, used it heaps since. Quote Share this post Link to post Share on other sites
Forrest 35 Report post Posted November 25, 2008 Paid about $90 from supercheap from memory, used it heaps since. Okay sweet thanks, will look into that. If anyone has any other suggestions that are cheaper...post up. Thanks Quote Share this post Link to post Share on other sites
c.robertson00 11 Report post Posted November 25, 2008 I just replaced my Control Arm bushes today and used one on those super cheap press's and it worked perfectly. I had to use a bit of heat to get the old bushes out though. Its far less stressfull and cheaper in the long run just to buy a press. Quote Share this post Link to post Share on other sites
OLLIE 26 Report post Posted November 25, 2008 environmentally friendly Gus burnt mine out but it took a while i would definitely recommend a cheap hydraulic press, could try trade me too Quote Share this post Link to post Share on other sites
antony 0 Report post Posted November 25, 2008 I also notice the hammer. Can't fix an E30 without a hammer, remember that kids. Quote Share this post Link to post Share on other sites
Silver Fox 43 Report post Posted November 25, 2008 Hammer's too small, needs to be much bigger. Quote Share this post Link to post Share on other sites