keen 6 Report post Posted May 1, 2010 Is it possible to take the tie rods off without damaging the tie rod rubber seal? I have a fork type tool to take the tie rod off but I can see that there is likely to be damage to the rubber seal.the tie rod was replaced about 1 year ago ans a stone or rock has split the steering boot and it looks like a complete steering arm off.any wise or easy shortcuts to this operation? a little help here would be muchly appreciated Quote Share this post Link to post Share on other sites
hotwire 352 Report post Posted May 1, 2010 I do it with an FBH (....en big hammer) & a drift. Give the pin housing a decent whack or two crack the joint loose. Can do with just the hammer BUT be accurate & leave the nut on loosely to protect incase you miss Quote Share this post Link to post Share on other sites
keen 6 Report post Posted May 5, 2010 Thanks for that it worked new boot nicely in place till another stone or rock hits it Quote Share this post Link to post Share on other sites
