alanmacc 0 Report post Posted August 20, 2011 Hi folks Well i finally tried to fit my new FSR but gave up before i killed the car or myself, cant get the last torx screw out of the housing. Any decent placed in Christchurch to go have it fitted, other than jeff gray was at it for 3 hours before i finally lost it, so now till its fitted i am driving with no heater atall Any help please Cheers Alan Quote Share this post Link to post Share on other sites
oscar90 0 Report post Posted August 20, 2011 kevin burt is my choice for anything on my E39. good service and a nice guy Quote Share this post Link to post Share on other sites
Greg111 13 Report post Posted August 20, 2011 Fan resistor you're talking about? They are cunty when you haven't done one before, if you get Jeff Greys to do it, they will take about 15min, it's like an art after a while, need special tool to get to one torx screw. Quote Share this post Link to post Share on other sites
alanmacc 0 Report post Posted August 20, 2011 thanks guys kevin burt might be my first stop, i assume its ok to drive the car with everything disconnected? the OBC plug, existing FSR ..... Took it for a short run seemed ok but thought id check Quote Share this post Link to post Share on other sites
alanmacc 0 Report post Posted August 20, 2011 kevin burt is my choice for anything on my E39. good service and a nice guyJust noticed your in rolly too . you wanna fit a FSR hahaha Quote Share this post Link to post Share on other sites
oscar90 0 Report post Posted August 21, 2011 nah bud haha sounds like a prick of a job! Quote Share this post Link to post Share on other sites