mossline 15 Report post Posted November 8, 2011 Hi guys, so a while back on a trip up the country i noticed one of my high beams were on, I pulled over, took the key out of the ignition and the light was still on. For a temp fix I just disconnected the bulb. But now WOF time is nearing..... I know its the LCM thats spazzed out but I was hoping to avoid touching the LCM and going down another route but would like your guys' advice on whether what i want to do will work ok or not? I figured I could just run a wire from the headlight that DOES work properly so that when it is activated, the offending side comes on too thus bypassing the LCM. Will this work ok? Thoughts/ ideas? Thanks in advance..... Quote Share this post Link to post Share on other sites
*Glenn* 854 Report post Posted November 8, 2011 The LCM can be repaired Quote Share this post Link to post Share on other sites
*Glenn* 854 Report post Posted November 8, 2011 I figured I could just run a wire from the headlight that DOES work properly so that when it is activated, the offending side comes on too thus bypassing the LCM. Will this work ok? Thoughts/ ideas? Thanks in advance..... This is likely to overload the LCM and throw a fault code on your display Quote Share this post Link to post Share on other sites
mossline 15 Report post Posted November 8, 2011 Thats what I figured but to be honest a fault code isnt really going to bother me as long as it works and doesnt mess up the actual workings of the LCM. Where would I send the LCM if I wanted to get it repaired and roughyl how much do you think I would be looking at? Thanks Glenn! Quote Share this post Link to post Share on other sites
*Glenn* 854 Report post Posted November 8, 2011 Thats what I figured but to be honest a fault code isnt really going to bother me as long as it works and doesnt mess up the actual workings of the LCM. Where would I send the LCM if I wanted to get it repaired and roughyl how much do you think I would be looking at? Thanks Glenn! Give me a call Quote Share this post Link to post Share on other sites
shaneg 0 Report post Posted November 8, 2011 How'd you get on with the trim painting? Turn out ok? Quote Share this post Link to post Share on other sites
mossline 15 Report post Posted November 9, 2011 Hahaha! Still not got round to it yet.... How'd you get on with the trim painting? Turn out ok? Quote Share this post Link to post Share on other sites
