328FTW 0 Report post Posted January 8, 2013 Ok so some of the studs on my new motor could do with replacement, trying to change the gasket the pre facelift manifold is a complete biyatch to get off and not only that the nuts were well rusted down, rounded and needed heat to get off at which point the threads picked up and a few were straight out gas axed off they were so bad. Does anyone sell a well priced kit or do I have to make up my own to suit? Either or, it's about $15 to make my own I guess; just time consuming. Quote Share this post Link to post Share on other sites
*Glenn* 854 Report post Posted January 8, 2013 Try our sponsor http://www.bimmersport.co.nz/forums/index....showtopic=10481 Quote Share this post Link to post Share on other sites
