e30 parting out

[Etwenty1 45]

A tidy Gold PFL E30 parts as below

Previous thread

Wheels - ON HOLD
Manual Conversion - GONE
Sunroof Panel - GONE
Headlights - $100 $80 the pair
Bonnet - $45
Doors less trims - $30
M20 radiator with shroud - GONE
Manual sunroof winder complete with knob, plate and screw $50
Wiper motor $40
Hood cable inc handle
Dash (couple of cracks)
Taillights $60 the pair
ICV $30
Coil $20




Windows and sunroof are manual winders, seats are ripped, door cards are a mid brown and would clean up ok.

Car is in Tauranga but happy to freight.

Edited September 29, 2013 by etwenty1

[328FTW 0]

Bonnet cable and windscreen wiper motor?

[marquis 18]

2door or 4door sedan?

[marquis 18]

says 4 door in title

Sorry. It's a Monday. Haha

[notsteve 0]

Instrument cluster?

Gearstick boot?

Edit: Also looking for the plastic demister venting pipe that is behind the instrument cluster

Edited August 27, 2013 by notsteve

[Etwenty1 45]

Shell will be going to scrap this week so any requests?

all front end parts look good, grille set $50, 1/4 panels $75 ea , bonnet $45, valence $25, chrome bumpers $60 the pair, can pull the power steering system complete $150 including rack and pump, no visible leaks.

4 King springs, including both front struts complete with calipers. $200.

325i exhaust $100

Would rather not have to store & TM stuff.

[Tidy30 38]

_{Quite an amateur question here with the King springs, but if they were into an E30 cabrio, any idea the delta height they would produce?}

_{I'm looking for some slight lowering, as the driveway to the garage is quite steep. Haven't done my research yet, but gotta start somewhere.}

_Thanks

Edited September 29, 2013 by Tidy30

[Etwenty1 45]

_{Quite an amateur question here with the King springs, but if they were into an E30 cabrio, any idea the delta height they would produce?}

_{I'm looking for some slight lowering, as the driveway to the garage is quite steep. Haven't done my research yet, but gotta start somewhere.}

_Thanks

I think the cabrio fronts are different to non-cabrio but someone more knowledgable might chime in?

I also have a e30 Msport set of complete struts and rears. Does you car have ABS?

pev thread for car http://bimmersport.co.nz/topic/33622-yet-another-e30/

Edited September 30, 2013 by etwenty1

[forty 0]

hey man have u got the fog lights for a pre face lift... or the plastic blanks that clip in where the fog lights would go

cheers

[Etwenty1 45]

hey man have u got the fog lights for a pre face lift... or the plastic blanks that clip in where the fog lights would go

cheers

Have definately got the blanks, think i have some fogs as well. WIll get back to you.

[Dave@nz 11]

Hi

Can you supply the rubber boots, plugs and about 500mm wiring for the fuel gauge/pump at the tank for pre face lift as seen in this link

http://bimmersport.co.nz/topic/45816-e30-fuel-sender-wiring-harness-and-boot/

Cheers,

Dave.

[Etwenty1 45]

Ill have a look if mine is the same but yes.

[APT 179]

Have you got any floor mats?

[Brook-e30 0]

Do you still have the front valence lip?

[Etwenty1 45]

Do you still have the front valence lip?

yes i still have a PFL lower lip, the black plastic part.