Ahmedsinc 414 Report post Posted December 9, 2014 (edited) Is there anyone around that has the ability to flash a 413 chip with S50B32 data? Have found a thread on an overseas forum where the OP ran an M54B30 on a red label 413 DME with a Turner / Dinan or similar chip to sort out the fuel etc tables. From what I've seen so far all the aftermarket stuff raises rev limit etc which I don't want. Any insight would be greatly appreciated! Edited December 9, 2014 by Ahmedsinc Quote Share this post Link to post Share on other sites
Ahmedsinc 414 Report post Posted December 10, 2014 Am I asking a taboo question? Or is this one in the too hard basket? Quote Share this post Link to post Share on other sites
polley 916 Report post Posted December 10, 2014 Not keeping the siemens ecu? Quote Share this post Link to post Share on other sites
Ahmedsinc 414 Report post Posted December 10, 2014 Not keeping the siemens ecu? Using M50 intake and single vanos so no point. Keeping everything just in case I change my mind. Probably a stupid question, but I don't suppose the Siemens chip would fit the Bosch board? Quote Share this post Link to post Share on other sites
polley 916 Report post Posted December 10, 2014 Using M50 intake and single vanos so no point. Keeping everything just in case I change my mind. Probably a stupid question, but I don't suppose the Siemens chip would fit the Bosch board? Not at all. I have done 402/405/413 stuff, but my burner has crapped out / playing up. Quote Share this post Link to post Share on other sites
Ahmedsinc 414 Report post Posted December 10, 2014 Not at all. I have done 402/405/413 stuff, but my burner has crapped out / playing up. Killer. Will send a PM tomorrow Quote Share this post Link to post Share on other sites
