Wanted: Crank Position / Speed Sensor for M30 *Urgent*

[_Matt_ 42]

anyone out there have one or two of these lying around? I believe it's what is stopping my E28 from starting since one doesnt pass the resistence test. I'm moving house in a week so it's rather bad timing.

Anyone got some working ones? dont care if they are bad condition, I'm buying new ones anyway, I just need to be able to drive it to my new place.

TIA

[BM WORLD 1283]

swap the 2 around (at both ends) , car will run on the one sensor , the main one is the one that works on the small trigger mark on the flywheel ,

the other runs on the flywheel teeth , but not that important to make it run ,

I take it ,its the factory e28 535i motronic setup? not converted to a e34 type setup?

[_Matt_ 42]

yep, factory setup.

out of a 635i I believe. Swapped them with no luck.

I'm only getting one correct resistance from point 1 to 2 of a single sensor, 1060ish ohms. Every other point on both sensors fail to read anything. The other points are suppose to shoot up to 100 000+ right?

[BM WORLD 1283]

did you swap at the gearbox and at the top where the plugs are

[_Matt_ 42]

I swapped the sensor positions and also tried turning the engine over with the plugs both ways around.