Jump to content

FIAT 131R

Race Series Competitors
  • Content Count

    785
  • Joined

  • Last visited

Posts posted by FIAT 131R


  1. I have 3 lots. I know one is black out of a motorsport and the other two are dark. Will have to check the colours to be sure. Two I had to trim under the console to remove to avoid removing the heater and the other I removed the heater to get it out. What a bloody mission.

    I will check the colours today.

    I HAVE A DARK GRAY ONE PM ME IF YOU ARE INTERESTED


  2. I am after some good condition carpet in the dark grey colour for my 87 E30 Coupe.

    I have 3 lots. I know one is black out of a motorsport and the other two are dark. Will have to check the colours to be sure. Two I had to trim under the console to remove to avoid removing the heater and the other I removed the heater to get it out. What a bloody mission.

    I will check the colours today.


  3. I have one here in Wellington. Not sure how you are going to get it up there as it would be difficult to wrap it up with the piping sticking out.

    ooops I have a full sunroof. I should have read the post properly. SORRY

  4. Looking for a replacement sunroof winder for my e30 ... some silly girl managed to snap it the other night -.-

    if anyone has onee anyways

    cheers :)

    I have one here in Wellington. Not sure how you are going to get it up there as it would be difficult to wrap it up with the piping sticking out.

  5. will these fit with most wheels and are the up to cert standard?

    I have only tried them using my BBS Wheels and they are fine. The length of thread on the bolts I removed from the E30 is approx 24mm. The length of thread on the wheel side of these studs is approx 30mm. They meet American standards and are sourced from there.


  6. 16 studs 44mm long and 16 black zinc coated wheel nuts for converting your E30 from those annoying bolts to studs. Much easier wheel changes at the track and on your road car. Note the Allen Key in one end for easy tightening. Make sure you Loctite the studs firmly in place. Yes they fit under the BBS centres. $139.95.

    post-5339-1301469286.jpg


  7. I bought an under pulley kit for the E30 with a 3 litre M54 engine in it. The gain was minus 1 horsepower on the dyno. I went back to the supplier and told them I was annoyed that their claims about HP gains were bullshit. They did not take kindly to my comments and said that unless the dyno runs before the kit installation and after were on the same day, same dyno same temperature etc etc they would not accept that there were no significant gains.

    My view is that it would be better to wait till winter and burn the $600 US that the under pulley kit costs and atleast you would get a little warmth from your money.


  8. The new format is a pain in the arse. Have I done something to my settings or has the format been changed. I see the topic in full then all the posts are listed below it. I have to open each post to see what is happening. I am a fast reader and used to scan read the posts as I scrolled down.

    I just switch off because I can't be bothered opening every single post. If the change has been designed to make us switch off participation it will work 100% for me.


  9. The cop woman Paula Rose who has been going on and on about how lowering the speed limit at Queens Birthday reduced deaths despite appalling weather and no one on the roads will get a huge bonus. Not because the road toll this Labour weekend has been low but because she will have gained huge revenue from additional fines and because she has become an accomplished liar. Watch the cops insist the road toll ould have been higher if they had not had the lower threshhold in place. No matter what they do they never ever admit they botch anything and our media repeat ad nauseum anything the cops say.

    Target the simple rules like keeping left, use of indicators, target slow drivers holding up other traffic, get people to stop if they are tired and have a cuppa and most of the traffic problems will be overcome.

×
×
  • Create New...