Search the Community
Showing results for tags 'adapters'.
Found 3 results
-
Hey team, I'm a bit new to the forums and have had my e82 135i for about 4 months now. I was wondering if anyone within the Wellington region has the MHD wireless adapter I could borrow to get my car back up and running? I stupidly couldn't wait and tuned my car with a shitty ebay cable. Managed to get it to stage 1 but I wanted to change to stage 1+ with 98Ron but in the process have failed a write. Now the cable wont work as well and fails to send a packet through close to finishing. Battery charger is fine/running an idling car while tuning. Thanks in advance! -
Hi Guys, I just bought my first wagon (2008 Msport 320i) and wanting to make a couple changes. 1. Wheels: I have purchased a new set of 19 x 8.5 inch m3 wheels with a set of 225/35/R19 tires (rims centre bore hole is 72.6mm) only to find out wagons generally run a staggered fitment so my rims at the rear may sit too far in the guards and therefore cause issues or just straight up look bad. I love the wheels so thinking I can buy a pair of these exact 25mm adapters to address the issue. https://www.trademe.co.nz/a/motors/car-parts-accessories/wheels-tyres/other/listing/2504454179 Will these adapters fit properly without vibrating and be able to be certified? Will I need locator rings? 2. Suspension: I am wanting to lower it as much as possible but without rubbing etc (I don’t mind rolling guards)so will adjusties work in this case if the above is completed? If I did adjusties and got certed does anyone know how low I can go legally if I get it certed due to camber angle restrictions etc? Or is it better to go with an alternative like super lows? Sorry for large post guys but just want to get some help on this before I spend waste time / money on mods that can’t be done/certed! Thanks for your time!
-
We need a pair of 20mm hubcentric spacers (preferably bolt on) for an e30. Center bore size is 57.1 and 4x100 pcd. The recess in the bak of the spacer, which centralizes on the hub, needs to be deeper than the standard 10mm that most spacers are as bmw hubs stick out more (13mm in our case i think). Have been hunting everywhere and coming up short. And we need them before the 4&rotor jamboree so ASAP!!!! Message me if anyone has any for sale
