mark247 38 Report post Posted September 17, 2007 Converting my 325i to a manual, got all the stuff out of a 320i other than the drive shaft. I have been told only a 320i manual shaft will fit into my car because the 320i manual gearbox i am going to use is a different length than the 325i manual ones. Does anyone have one??? Thanks. Quote Share this post Link to post Share on other sites
skidz 196 Report post Posted September 23, 2007 Converting my 325i to a manual, got all the stuff out of a 320i other than the drive shaft. I have been told only a 320i manual shaft will fit into my car because the 320i manual gearbox i am going to use is a different length than the 325i manual ones. Does anyone have one??? Thanks. I thought 325 and 320 gearbox were same length? Did you measurethem? Quote Share this post Link to post Share on other sites
mark247 38 Report post Posted September 23, 2007 I thought 325 and 320 gearbox were same length? Did you measurethem? I have one now, from a 320i. Nah i was told by HellBM guy or whatever, that the 240 and 260 gearboxs are different lengths so hense a different length drive shaft. Quote Share this post Link to post Share on other sites
tibbs.james 1 Report post Posted September 23, 2007 You could speak to your vechicle certifier about who could lengthen your auto driveshaft and rebalance it ect. might only cost a hundread or two Quote Share this post Link to post Share on other sites
mark247 38 Report post Posted September 23, 2007 You could speak to your vechicle certifier about who could lengthen your auto driveshaft and rebalance it ect. might only cost a hundread or two nah i got one now so its all good Quote Share this post Link to post Share on other sites
