smiddy 76 Report post Posted July 7, 2008 Any one have any E30/ M20 gaskets new or good cond used? Quote Share this post Link to post Share on other sites
*Glenn* 854 Report post Posted July 7, 2008 Any one have any E30/ M20 gaskets new or good cond used? To do what ?? Quote Share this post Link to post Share on other sites
smiddy 76 Report post Posted July 7, 2008 To do what ??Sorry Glenn, exhaust manifold! Quote Share this post Link to post Share on other sites
*Glenn* 854 Report post Posted July 7, 2008 Sorry Glenn, exhaust manifold! You need new gaskets...not 2nd hand Quote Share this post Link to post Share on other sites
tibbs.james 1 Report post Posted July 8, 2008 If you are replaceing the Manifold to cylinder head gasket its also a good time to check that the surface of the exhaust manifold is level agaisnt a striaght edge, otherwise your new gasket might not last long. I though i was being fussy when i had mine planed just to be sure, but it needed 3 goes at getting it level as it was quite badly out at one end. I also used extreme temp RTV just to make sure it didn't bloody leak again. ( i seem to have exhaust issues on every car i own- bad luck for me maybe ) Quote Share this post Link to post Share on other sites
*Glenn* 854 Report post Posted July 8, 2008 I would also replace all the studs & nuts as well...but it sounds like he's trying to do it on the cheap, or maybe I'm wrong. He didnt say what or why he was doing it Quote Share this post Link to post Share on other sites
tcbaurpower 5 Report post Posted July 8, 2008 Hello, I just brought a whole head gasket set includes everything for head up for $140. If you just need a manifold gaskets it should not be expensive. And if you just need the manifold to exhaust then it only cost me $5. I got all new washers and nuts for both the manifold and air in take and tempostat housing (26 in total) and it cost me $27. No reason to go second hand on these parts. Adam Quote Share this post Link to post Share on other sites
c.robertson00 11 Report post Posted July 8, 2008 (edited) Where abouts was that from? Edited July 8, 2008 by chris00 Quote Share this post Link to post Share on other sites
tcbaurpower 5 Report post Posted July 8, 2008 Gaskets from repco. Nuts and washers from Blacks Fasteners. Take the old gaskets to match from so they dont get it wrong. Quote Share this post Link to post Share on other sites
Five Star 0 Report post Posted July 8, 2008 Just done this. Euro italian (forum sponser) is your answer! Quote Share this post Link to post Share on other sites
