[email protected] 0 Report post Posted January 21, 2010 Right, so I've been looking around the last couple of weeks for options to upgrade my stock M50 Vanos intake & exhaust camshafts The options seem to be M50B30 US cams... but they seem extremely hard to source being from US models. The other, Schrick cams, and I'm guessing a few other after market cam manufactures but what is a good local solution here in New Zealand for upgrading cams without importing stuff from the states etc? Also has anyone done cam upgrades on their Vanos M50, with dyno results, some I have seen show good figures, but I think its better telling from more local results rather that ones from USA or Europe. Any help would be good. Cheers Mike. Quote Share this post Link to post Share on other sites
[email protected] 0 Report post Posted January 24, 2010 No one here has done any upgrades? Quote Share this post Link to post Share on other sites
my_e36 43 Report post Posted January 31, 2010 Are you sure it's M50B30? I did hear of S50B30US cam swap (US spec M3 cam). http://www.dtmpower.net/forum/australia/15...2us-debate.html Quote Share this post Link to post Share on other sites
_ethrty-Andy_ 2132 Report post Posted February 1, 2010 i think you can put a M52B28 crank in the M50B25 block. but please research before buying anything coz im not 100% sure, may have got wires crossed etc Quote Share this post Link to post Share on other sites
*Glenn* 854 Report post Posted February 1, 2010 i think I may have got wires crossed etc Yes you have... he was talking about camshafts Quote Share this post Link to post Share on other sites
[email protected] 0 Report post Posted February 1, 2010 (edited) Haha yes. Also S50B30US. I wrote M50B30. Whoops! Dont worry about this thread anyway, I've been talking and aiming to replace the motor with another. Dear I say.... a non-BMW motor Edited February 1, 2010 by Mike-E34 Quote Share this post Link to post Share on other sites
_ethrty-Andy_ 2132 Report post Posted February 1, 2010 Yes you have... he was talking about camshafts lol i didnt mean my wire crossing to be THAT explicit!! Quote Share this post Link to post Share on other sites
kerrynzl 3 Report post Posted February 15, 2010 i think you can put a M52B28 crank in the M50B25 block. but please research before buying anything coz im not 100% sure, may have got wires crossed etc While on the subject of crossed wires , I will confirm that you can put the whole rotating assembly from a M52B28 into a M50 iron block [ I have one sitting on my engine stand ] The mystery is solved haha! Quote Share this post Link to post Share on other sites
antil33t 90 Report post Posted February 15, 2010 Dear I say.... a non-BMW motor Barra 310T or bust. Quote Share this post Link to post Share on other sites