gouba 0 Report post Posted October 31, 2010 (edited) I have been wanting to lower my car a little, so that the gap between the front tyre and wheel well looks correct, The chassis rails are at 108mm at the moment and to get rid of the gap they would most likely end up at around 90mm. I want this to all be legitimate so three questions Would it be reasonably easy to get a certification for this if lowered correctly? Can anyone recommend a good certifier for this What could I expect to pay for this service? Thanks in advance Edited November 1, 2010 by gouba Quote Share this post Link to post Share on other sites
5amchris 45 Report post Posted October 31, 2010 If done right then should be fine. And you would look at a cost around $400 [Thats what i paid] Quote Share this post Link to post Share on other sites
E36ShoppingTrolley 7 Report post Posted November 1, 2010 i wouldnt bother getting a cert for just 10mm off, but then again i could get told off for saying that . Quote Share this post Link to post Share on other sites
_ethrty-Andy_ 2132 Report post Posted November 1, 2010 10mm or 70mm below the legal limit, the 5-0 dont care. rules are rules Quote Share this post Link to post Share on other sites
CamB 48 Report post Posted November 1, 2010 What tyres are you using? Quote Share this post Link to post Share on other sites
APT 189 Report post Posted November 1, 2010 Where are you located ? Quote Share this post Link to post Share on other sites