Jump to content
Sign in to follow this  
323e30

Massive Clearout Begins Now.

Recommended Posts

Its comming up to that time of year again and I have 19 cars worth of parts to clear out time to pay the bills!

e36 318i gm automatic gearboxes from 200$

51mm front struts complete 90$ pair

twin cam 318i engine 1996 complete 650$

16" e39 alloy rims with tyres 350$

15"e35 alloys with tyres 180$

14"e30 bottle tops with tyre 170$

260 manual gearbox for m20 from e34 200$ (in wellington)

323i automatic zf 5hp-18 gearbox e36 200$

m30b35 engine complete 400$

m30b30 engine bare 100$

rear monroe e30 gas shocks pair 60$

bonnets e30 from 25$

doors from 30$ guards from 40$ e30 e34 e36 e32

ecus from 30$ interior parts from 4$

Lowering springs Kings 100$ e36 Very low

standard springs 10$ a coil

e36 headlights 80$ each

e30 front grills and headlight surrounds 10$ a peice

alternators from 60$

starter motors from 50$

stripped straight Shells with live plates, e36 compact,

body cuts

leads, coils, bumpers,

List goes on!

Loads of stock just ask or come into the yard.

can post anywhere in nz

9.30am-7pm Monday to Friday

22 Oakleigh Ave Takanini

09 268-9657 0210390073

[email protected]

Mention your from bimmersport to get these prices when you come in!

To be fair its first in with cash first served, wont hold anything for anyone

Starts now! Just Ask if you need anything

Edited by 323e30

Share this post


Link to post
Share on other sites

Do you have a front lip for an e30 and postage to Hamilton.

Also the metal bit for auto's that says M-E-321 to change how the auto reacts

Share this post


Link to post
Share on other sites

keen for the M10 manual box, just gotta sort my move home etc first

Share this post


Link to post
Share on other sites

E30 260 gbox?

Have the 260 in wellington but it has the larger output on it, so if you have a flange ull be fine but otherwise ull need to customise your d shaft

Share this post


Link to post
Share on other sites

Do you have a front lip for an e30 and postage to Hamilton.

Also the metal bit for auto's that says M-E-321 to change how the auto reacts

What year is your car? fairly sure all the lips are gone, but 40$ if in stock .

Share this post


Link to post
Share on other sites

No worries, just lemme know when your ready

Sweet will be in contact in a short while... I'll have to sort it logisticaly too

Edited by nath

Share this post


Link to post
Share on other sites

Whats the drop on the H&R springs ?

Share this post


Link to post
Share on other sites

I'm after e30 6 cylinder instrument cluster (in km, not miles). I can pickup.

Only have one here , Motometer brand from a 325i facelift e30 in Kms , reads 125k on clock. 45$ Picked up + 9$ to post

Address and open times in the main description, just pop past when your ready here today till 7

Share this post


Link to post
Share on other sites

Hi, do you have any M20 cylinder heads for an E30 (6 cyl, 2L). Ideally facelift, but pre facelift will also be ok.

If so how much?

Share this post


Link to post
Share on other sites

Only have one here , Motometer brand from a 325i facelift e30 in Kms , reads 125k on clock. 45$ Picked up + 9$ to post

Address and open times in the main description, just pop past when your ready here today till 7

What do you mean "Motometer Brand" ? are there any other ones ? I'm just after stock factory one. nothing fancy...

Share this post


Link to post
Share on other sites

Hi, do you have any M20 cylinder heads for an E30 (6 cyl, 2L). Ideally facelift, but pre facelift will also be ok.

If so how much?

Have a pfl one here, 60$ has been sitting for a while but should still be ok. come out and have a look if possible

m20b20

Edited by 323e30

Share this post


Link to post
Share on other sites

Anything for an E46 at all?

Not really just a 318i engine from an e46 that has a blown head gasket. Rays the man to see for e46 parts

Share this post


Link to post
Share on other sites

e30 everything to convert to manuel besides clutch motor car is e3o 320

have slave cylinder 20$ pressure plate 40$ flywheel 80$ dont have much else

Share this post


Link to post
Share on other sites

e34 e32 4hp-22 zf auto trans with mode selection switch 200$

e30 coupe doors, White, 50$ each

e30 windscreen 50$

325i e30 Bosch inline fuel pump 45$ (one only)

e30 coupe side glass 30$ each

e30 rear disc brake setup complete with traling arms 80$

e30 45mm front struts complete with shocks and springs 60$ pair 40$ each

e30 325i rear swap bar with links and mounts 50$

e36 locked diff 50$

e30 e36 aftermarket rear bumpstop seats, Thinner and shorter than standard 15$ pair

e30 rear monroe gas shocks 50$ pair

e30 ignition barrel and key 40$

1 car down and gone 18 more to go.

Share this post


Link to post
Share on other sites

What do you mean "Motometer Brand" ? are there any other ones ? I'm just after stock factory one. nothing fancy...

there are two type , vdo brand or motometer brand both came in the e30s from factory but they slighly vary between the two. (fuel reading, and inspection lights differ)

Share this post


Link to post
Share on other sites

Hey Mike,

Looking to replace dull faded old headlights in the E30 325i 1987 non Sealed beam during my Christmas go crazy swap an engine into the coupe time.

The current ones are looking really rather bad and the inside reflector bit is starting to chip away in areas

Not too worried about the style

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...