Kaz 64 Report post Posted July 21, 2013 Hi there, So I was trying to switch my old basketweaves onto my new e30 but for some reason the center bore was too small and wouldn't fit on the rear wheel hub? Front seemed to fit alright. They fit fine on my old SA 1990 BMW 325, and currently on my 1987 BMW 318i, but they just wouldn't fit on my UK 1989 BMW tech 2 325. As far as I know everything is all standard on it. Any idea why this might be? Quote Share this post Link to post Share on other sites
Allanw 1071 Report post Posted July 21, 2013 Rust or Corrosion on either surface? It doesn't take much. Quote Share this post Link to post Share on other sites
Kaz 64 Report post Posted July 22, 2013 Rust or Corrosion on either surface? It doesn't take much. Nope there wasn't any rust or corrosion, I even tried scrubbing it down if that was the case. Seemed very weird to me, as it was sticking out a good 5-10mm out from the hub. Quote Share this post Link to post Share on other sites
BM WORLD 1283 Report post Posted July 22, 2013 (edited) check there are not some hubcentic rings stuck on the hub or wheel , but otherwise rust etc Edited July 22, 2013 by Brent HARTGE535i Quote Share this post Link to post Share on other sites
Kaz 64 Report post Posted July 22, 2013 check there are not some hubcentic rings stuck on the hub or wheel , but otherwise rust etc Hmm I didn't notice any. I'll take them off again this weekend to have a better look. Quote Share this post Link to post Share on other sites
