allan 295 Report post Posted April 5, 2020 Yesterday drove it outside and set up the table tennis table. Going to do a little stress relief haha. Over the last few days been looking at the rear PDC and reverse beep. Checked the painted rear sensors I had and found they all had different part numbers and some A1 , A3 what ever that is. So checked the other set I had and these where all the same so fitted them. After checking the wiring colours and pin placings which all checked out I tested for power , ground, gong activation. Now has a tone when reverse is selected but still no tone from the PDC further checking to be done.Anyone have any ideas thanks. Thanks to another member now have a set of neew wheels at staggered set of style 97's Quote Share this post Link to post Share on other sites
Gaz 1060 Report post Posted April 5, 2020 Scan it, see if any of them throw fault codes Quote Share this post Link to post Share on other sites
allan 295 Report post Posted April 5, 2020 Durr didn't even thing of that Thanks. Quote Share this post Link to post Share on other sites
