Jump to content
Sign in to follow this  
Polemic

Could multiple fault codes be caused by one fault

Recommended Posts

So after totalling my beloved and reliable 2001 330Ci, I've bought a 2009 525i. The onboard computer shows nothing amiss beyond being overdue for a service (which has actually been done but my mechanic couldn't reset it).

Today, the check engine light came on. I assumed it was complaining about what it saw as an overdue service. But out of curiosity I ran the OBDC I have over it, and got more codes than Alan Turing at Bletchley Park.

These include (some codes may be wrong as my photos of the screen have reflections):

93FB - control-module fault
9408 - undervoltage during self test
A3B1 - signal or value below threshold
A559 - Supply was switched off (terminal 30G - f)
A2CD - control unit undervoltage
A46D MOST - ring reset fault
5B69 - wheel speed sensor rear axle: mixed up (!!)
SF4B - Interface, instrument cluster
5DCF - Control module, under-voltage
5F45 - brake fluid level too low (this was topped up during the service just before Christmas)
6140 - redundancy comparison, driver's steering angle
A830 - resetting system faulty
A83B - Undervoltage
93D0 - Undervoltage
A409 - Undervoltage
931D - System voltage

When the car was trucked from Auckland to Wellington it took so long the battery went flat. I therefore invested in a new one from the AA at over $750 (on top of several thousand $ getting my dad's old car going as a back-up for the family and for sentimental reasons, plus of course the purchase price, all right before Christmas) 😬 So the multiple undervoltage faults can't be traced back to the battery.

So my questions to the brains on this forum are:

  1. What's the possible cause(s) of the undervoltage reading?
  2. Could undervoltage be causing all, or at least some, of the other faults to show up?
  3. Why is the onboard computer showing everything okay other than oil and brake fluid?
  4. Obviously I'll double check the brake fluid visually, but aside from that is there anything here that's absolutely dire and could affect the safe operation of the vehicle or damage it if not addressed immediately?
     

Share this post


Link to post
Share on other sites

The undervoltage codes are almost certainly because the battery is low, thats what that means, just because it is new doesn't mean it is full!! A low battery can cause all sorts of codes in these, the problem will be figuring out what is sucking all the power out of the battery, I am going through a similar issue with my M5 at the moment, I keep a trickle charger on it all the time otherwise it won't start after a few days, and it had a new battery in November!

Contnental cars kept it overnight and did an energy diagnostic but didn't come up with anything concrete so I am still trying to figure it out....

  • Sad 1

Share this post


Link to post
Share on other sites
8 minutes ago, Polemic said:

So the multiple undervoltage faults can't be traced back to the battery.

They absolutely can, especially if they are historic codes.

Being a 2009, i presume its an E60, in which case was the new battery correctly coded to the car?

Clear the codes, drive it a bit, and see what comes back.

Share this post


Link to post
Share on other sites
Just now, KwS said:

Being a 2009, i presume its an E60, in which case was the new battery correctly coded to the car?

Yes, an E60. Well the AA guy said it was coded correctly, but then again, he didn't seem too sure.

Quote

Clear the codes, drive it a bit, and see what comes back.

I will try that tomorrow, thank you 👍

Share this post


Link to post
Share on other sites

Thanks KwS, I cleared the codes on the 8th and have been driving it for three days (I work from home so generally don't go far, so wanted to get some kms on it). Most of the codes have remained clear.

Two, however, have recurred late today (the 11th), relating to the VANOS system, so I'm assuming they're probably for real.

I'm still not sure if the battery was correctly coded to the car, though. That doesn't seem to be something the OBD reader checks for? However the lack of undervoltage faults leave me optimistic that it's okay, one way or the other.

 

Edited by Polemic

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...