E36 FLYWHEEL TORQUE SETTINGS

[kerrynzl 3]

Anybody out there in Bimmerland know the Torque Settings for a manual flywheel & pressure plate for a M50 Engine [Foot / Pounds]

Also where can I get [buy] the sockets for those 6 point cap-screws [bellhousing bolts & rear CV's]

Chairs [Cheers] Everyone

[BM WORLD 1283]

power built make kits of those stare sockets etc , from repco or ,most tool and engineering shops .

will get back to you about the torque settings , i have a manual , buts its late and its in the garage .

thanks for dropping off the gearbox .

ps. what year and millage did the car it cam efrom have .

cheers brent

[kerrynzl 3]

I was told 1990 E34 ,Mileage I'm unsure

[Gus 5]

FT for the flywheel, in the right order, with locktite

not so FT for the PP...they allen bolts anyway, weak as hell

[kerrynzl 3]

Hey Gus, slight misunderstanding .I'm after the Torque settings in Foot/Pounds or Inch/Pounds [because My old W&B Torque Wrench is Imperial] If someone can only supply the figures in Newton/Metres it will do

I aggree with You about Flywheel & PP bolts [i've seen 'em come off too many times] I always Torque them

[Grant 4]

Gidday Kerry

Here is what the manual says:

Flywheel to crankshaft 105 Nm (77 ft-lb)

Pressure plate to flywheel

M8 8.8 Grade 24 Nm (18 ft-lb)

M8 10.9 Grade 34 Nm (25 ft-lb)

This help?

Good to meet you the other day as well, hope my wonky directions got you onto the motorway ok.

Cheers

Grant

[kerrynzl 3]

Thanks for that Grant, Yeah those directions were OK

[westy 614]

Ha.

Seems we have 2 of these happening at the same time .Woot.

BMWs the way god intended