10hove
-
Content Count
177 -
Joined
-
Last visited
Posts posted by 10hove
-
-
-
Thanks Andrew your right
I have had a bit of a tidy up , as always in too much of a hurry.
It is a work in progress and Im always keen on ideas to improve it.
I've tried to keep it as simple and easy as possible and we have had an incredible response so far .
As far as I know we have the simplest application and approval forms in NZ .
cheers
Alex
-
Shameless plug
I've just started a finance website
You can check it out here
We will finance any registered car (including race cars)or motorcycle .
Finance rates are a bit high at present but its fast simple and easy , if you let me know your from bimmersport I see if I can bring the rate back a bit.
cheers
Alex
-
if your still having isssues give me a call Ive just been through all this myself , early cars had a couple of differnt versions of EWS or Drive away protection,
If we can identify exactly what you have Ive got some info that may help
cheers Alex 0275 024 817
-
with thin diagaonal stripes call alex 0275924817
-
over the last 12 months weve had over a dozen 5 series and 7 series with these sysmptoms in nearly every case it has been the airflow meter.Either Bosch YTTRIUM FR 7 LDC+ or FGR 7 DQE+
after replacement all clients report both better performance and economy.
regards
alex
carspot
-
As Glenn said, be careful with those hot wire systems, when you turn off your car they normally put thru a quick burst of increased voltage to burn off any crap.
As for dyno before/after,waste of time/ money if you have faults, get everything addressed first....not sure if this is any help but in the latest TBMW mag they talk about the E39 M5 afm being a weak point, faulty units cause big pwr drop offs...................these two(2x units on M5) small plastic tubes are the key to the M5 & with new ones it's like having another 100hp!
Sounds like the daignosis is spot on we have replaced dozens of these, usually with an immediate improvement not only at idle and low speed but also performance an around a 10% increase in fuel economy.
Up until now we have always used genuine replacement at around $900. we do have an insert avalible now that will fit certain meter housings though.
Feel free to give me a call
Regards
Alex
Ph 0800 924 817
-
http://www.carupdater.com/cars/used/carvie...aler=1012181243
Rebuilt to 3.5L thousands of dollars spent, truley well maintained by an absolute car enthusiast
give me a call or pm if theres any interest
alex 0275 924 817
-
Ive been meaning to set up some static pages on my website showing the range of used BMW popular in NZ
E36-E46 E39 etc etc as well as helping our website and sales it could be a good resource and include relevant links
But Ive sort of run out of time , if anyones interested would be happy topay.needs to be fairly simple with relevant images etc any one intersted in the job or know of anyone feel free to PM me an knowledge of BMWs a must
would love to have a coverflow page of all the models ??
could lead to more website work rate negotiable
chhers alex
-
Sorry mate, but the only way to know flywheel power is if you remove the engine & place it on a bench engine dyno.
Those dyno calculations are way out, thats what all the guys in the know told me.
Very true but thats why a base run will still give a comparison of the gains as long as the car is run on the same dyno even if its not a 100% correct figure I have dynoed over over 10 race cars on the same dyno most many times over so have a pretty good idea, anyway the point wasnt to argue horsepower theres plenty of that on the web as the say when the green flag drops the bullshit stops (but I suppose now its red lights that go out for the race start)
By the way the BMW race club in Britain runs the a class based on weight and dynoed horespower (same dyno) and the figure they produce are for M3s are from 270-360hp
The point of this post was performance mods for M3 anyway not dyno figures so I dont intend to get into that, the real point is you need some form of measurement.
cheers
Hove
-
Heres an old fellas view ( I do have an M3 3l race car and a bussiness that specialises in BMW sales and service)Holy crap that thing is awesome, I must find out if it can handle boost...
So while all these add on and bits available on line are tempting these are the steps I would suggest if you are serious about performance
1) check the car is up to standard as close as it can be to when BMW manufactured it (after all its a few years old )
This means compression check and maybe a leak down test . If it doesnt come up to spec your wasting you money on any add ons.
2) make sure all the servicing is up to scratch in particular oils etc but also that the vanos operates correctly and that it has no seals leaks etc, pay particular attention to the cooling system and clutch, after all if you are going to be thrashing it you dont want to incurr expensive repairs.
3) If you are going to do any performance mods you need a base run on the dyno this will tell you if the mods work
your base run will also point to any other faults and check that the car is performing as it should and most importantly that the air fuel ratio is optimum . BMW are always pretty conservative with HP and your car should pull some pretty good numbers if its running right, if not it may need a new air flow meter to get the mixture spot on.
Once youve done all this you can start to look at gains,
Personally my car is standard except for the addition of a twin plate clutch set up and very light (almost non existant fly wheel and a custom tune "superchip")
Ive posted a pic of the dyno chart 257 KW (344Hp) at the engine is not bad I think, (especially as its done 210,000kms) so the standard set up is very good you could spend a lot of money on go fast bits and actually go slower if you dont get it right or the car is not right in the first place.
anyway thats my 2 pennies worth
cheers Hove
-
HiGood headers and exhaust with re-mapp, you will probably gain in fuel consumption also.
saw your car today looks good
I would suggest you do a base run on the dyno anyway to see where you at ,you will need it to compare anyway should you do any mods at all,also if your air fuel ratios are off it could point to other faults.
John butler at tunning and performance would probabaly do you a deal to run it up on thier Dyno Pak
should be plently of dyno posts on the web to see how yours matches up
with my race car I always do a base run, compression check and run new plugs and best possible fuel, 98 will make differnce as the ECU will retard if it senses detonation at any point, easy to do if you are heavey footed
cheers alex
Carspot
-
http://www.trademe.co.nz/Trade-Me-Motors/C.../p-73800246.htm
jut had this arrive and pretty hard to find in black at this price kms are a liitle high but it drives really well
hove
-
oh wow, i was looking at this yesterday. My heads mixed around at the moment if i want another e36, but Straight up what is your bottom doller?
Feel free to give me a cll if you want to discuss price cheers
alex
-
-
03 735iAL around $30 k 2 available
330 Ci is a little hard in manual as they are usually nz new or sometimes ex Uk will keep a look out
Not looking to sharp to rebuild the M3 motor for puke unless I sell some cars or find a sponsor
I also have a mint 750il in japan black (M sport I think) 98 done 56 KMs that i need to cash up this is last one that will comply under the new laws
feel free to call me on anything else 0275 924 817
-
As most members may have noticed along with all used cars BMW prices have come back, so that what you get for the same price you paid last year is a much newer car. While this has been pretty painful for owners and dealers like me it great news if your a buyer.
We have just recently scored several new suppliers who are supplying cars for us to clear at really good prices we now have over 200 late model used BMWs available at some very good prices.
Latest arrivals include Z4, X3, and Mini cooper S
feel free to give me a call any time if there some thing your after finance and trade ins are welcome
Hove
0275 924 817
(sorry for the blatant sales pitch but times are tough and I have a race car to pay for)
-
Weve just traded this white 97 320 M Sport has done 170km but sold and serviced by us previoulsy sports exhuast M3 carbon Mirrors looks great in white gear box is good weve got $7990 on it but would negotiate it Finance avaliable
Cheers Alex
-
we need to clear some old stock for cars arriving this week check my trade me listings
http://www.trademe.co.nz/members/listings....rder=price_desc
might do a little better for bimmersport members for quick sale
cheers
Hove 0275 924817
-
http://www.trademe.co.nz/Browse/Listing.aspx?id=143917409
Tidy car Well maintained new cambelt nd water pump
cheers hove
-
Thanks for that, I'd hoped it was as simple as getting a new Nav DVD, and the iDrive would just use that... but I'll do some research and let you know how I go!
cheers
Hi Ive got the same car but 04 model unfortunately on standard wheels , BM workshop can up grade the radio software for NZ its an overnight job give them a call.
My understanding of the Nav is that it requires at least one complete new module ($3K) from memory and that even then there is no guarantee that it will run with the software. BMW require customers to sign a disclaimer for any software upgrades in case module go down.
My advice is to leave it alone until there is a proven remedy.
Also make sure the engine and trans oils are EXACTLY as specified by the factory
any variation will cause major issues , they are not car that tolerate being serviced outside factory specs.
have fun
alex
-
need an auto trans computerWrecking out a E34 535 SE
Looking for a part, just ask
nos
Bosch 260.002.050
1216 860.9
Bosch trans computer 88 535
cheers alex
-
i am your man .
20years plus in sales .
keen bmw man .
problem is i live in papakura .
not sure whats worse driving through trafic into mt eden or down the main trunk line to hamilton .
do you guys just specialise in BMW's
thats right just BMWs, mostly under 30K usually have between 30-50 in stock
-
I am looking for someone with proven car sales experience who has good BMW product knowledge for our new shop in Hamilton.
email : sales @carspot.co.nz
Cheers
Alex
Technicians wanted CARSPOT-Hamilton
in General Discussion
Posted · Edited by Alex ten Hove · Report reply
whoops posted twice sorry
Hi
After heaps of ads and hundreds of applications form unqualified techs overseas, I thought I would post here to see if there are any qualified techs passionate about BMWs about .
We can offer clean modern facilities, top level diagnostic and programming tools and above average rates of pay.
Feel free to give me a call 0275 924 817
cheers
Alex