Blackfrogg

Sweeeet easy welding. Thanks for the info

Stainless or na?

lol I think he thought intake Im pretty sure the m50s were cast from what Ive read so far but cant find any solid info on the m52s

What are the m52 exhaust manifolds made of? Need to know for some welding modifications. Thanks

Thanks for the info I think I will do the one sensor later down the track. Yea I had heard as much about the sensors but figured someone might have the hook ups to get them cheaper than pelican parts

beat me to it

Im not sure how these work exactly but i wouldve thought having just the one sensor in one of the manifolds would only read half the oxygen (hence the m50 having it after the separate manifolds and the m52 having one in each) going out and it would compare it to the full amount of oxygen going in? which would screw up the fuel to oxygen ratio

Wasnt too sure where the best place to post this was but here we go anyway. Im doing the e30 m50 swap and instead of using the m50 exhaust manifold im using the m52 manifold. The m52 manifolds have a place for an oxygen sensor to fit into each manifold (2 total). The m50 manifold didnt have anywhere for an oxygen sensor to fit but from what i understand it had a place after the downpipe (1 total). My question is do i bung both the holes in the m52 manifolds and put just the one sensor later down in the exhaust system or will it get a correct reading if i bung one of the holes and put a oxygen sensor into just one of the manifolds? Thanks

After a m50 lambda sensor or two

did this sell?

Looking for some m52 headers

Thanks again for the info! I got about 3 pages deep into the forums an decided to call it a night haha. I'm in Auckland but the guys you went with seem like a good deal might check then out

Cheers for the info. I had hoped as much would be true to save me having to find some rare starter that matched both

my 240 is out of a 318i but they came in the 320 and 318is too

Wondering if anyone knows a good place to go to get this done and at what sort of price. have a m20 flywheel

Looking for a starter motor for a e30 m20 flywheel but one that will bolt to a getrag 240/

You're the man Geoff

Need e36 driveshaft from a manual 325i and a m20 flywheel. Thanks

$900

Bump

Yea looking to widen. Saw a post in the wheels forum about a guy in Wellington who made them for (from memory) $900 for a set? Possibly the same guy, it might've even been your post haha

Looking for 15inch BBS RS lips (30 hole). New or used any size just wondering if anything is out there before i buy brand new ones

Bump

Forgot to add it is vanos

Auckland. Mount Albert to be more specific. I have an engine crane that can be used to load/unload and a van to transport it or you can arrange transport yourself