5 series clutch

[joel 0]

Hey guys, im after a clutch kit for my e28 m535.

Wouldnt mind getting a slightly better one from overseas but its hard to find for my model.

would a e28 m5 clutch like this one fit?

http://gripforce.com/store/index.php?main_...;products_id=53

Or any suggestions?

Cheers

[Guest Simon*]

Before Glenn suggests it Willy check out UUC in the states - I am gonna look at them for mine when I redo it.

http://www.uucmotorwerks.com/

[joel 0]

Before Glenn suggests it Willy check out UUC in the states - I am gonna look at them for mine when I redo it.

http://www.uucmotorwerks.com/

That was quick nerd, cheers. had a look but the oldest i could find on that site was e34

[*Glenn* 854]

That was quick nerd, cheers. had a look but the oldest i could find on that site was e34

E34 had M30 motors as well... does yours have crankshaft sensors on the gearbox bell housing ???

If it does...I dont think UUC can help...try emailing [email protected] and ask him

Or you could try Auto Clutch here in Auckland

Edited May 11, 2009 by *Glenn*

[joel 0]

im not too sure, dose this help?

[*Glenn* 854]

im not too sure, dose this help?

Yes...has the two sensors in the bell housing....lower right in the picture....email Rob, but I dont think he can help you...try anyway

[joel 0]

Yes...has the two sensors in the bell housing....lower right in the picture....email Rob, but I dont think he can help you...try anyway

Cheers

[BM WORLD 1283]

that one in the link looks ok ,.

make sure its for a single mass flywheel , also lighten your flywheel by about 2.5kg while you are at it .

10kg for normal m535i flywheel . m5 uses a 7.5kg one . just had mine done , engine picks up quicker now.

i have got clutches from auto clutch in morningside (ak) about 300-400nzd for a complete kit incl bearing

and he can do beafier ones if you think you have too much power for a std one

[joel 0]

that one in the link looks ok ,.

make sure its for a single mass flywheel , also lighten your flywheel by about 2.5kg while you are at it .

10kg for normal m535i flywheel . m5 uses a 7.5kg one . just had mine done , engine picks up quicker now.

i have got clutches from auto clutch in morningside (ak) about 300-400nzd for a complete kit incl bearing

and he can do beafier ones if you think you have too much power for a std one

Cheers, its in there getting ligthened at the mo

Shippings more expensive than the clutch its self from overseas so ill just get one here.

might give those guys a call