2052NV 43 Report post Posted October 8, 2013 i can help you do diff, just get me a mig but seriously i can halp you swap sh*t over Quote Share this post Link to post Share on other sites
HaNs 226 Report post Posted October 31, 2013 Been tracking down parastic battery drain, removed half my dash and disablded aftermarket alarm. In the end it seems to be the boot light drawing around 0.7 amps. Chucked in a LED bulb and its down to around 0.1 with just the boost open....hmmm, time will tell 1 Quote Share this post Link to post Share on other sites
HaNs 226 Report post Posted November 6, 2013 New rack ends and ball joints showed up this am along with new foam backed fabric for the door cards(only $20 per 1m x 1.5, so worth doing) Quote Share this post Link to post Share on other sites
HaNs 226 Report post Posted November 6, 2013 (edited) Passenger side done, no perfect. But way better than before Edited November 6, 2013 by HaNs Quote Share this post Link to post Share on other sites
lord_jagganath 421 Report post Posted November 7, 2013 (edited) ^ do those come in wide enough sizes to do the roof lining? Lovely work btw, EDIT: scratch that, just noticed the 1.5m width, wouldn't be enough Edited November 7, 2013 by The Juggernaut Quote Share this post Link to post Share on other sites
qube 3568 Report post Posted November 7, 2013 http://www.wwiggins.co.nz/formwcs0159289/Contact-Us.html Got my fabrics from here in the past. Cost about $80 ish for enough material for roof headlining and door cards for an e36. Then about $20-30 on some glue from bunnings. Quote Share this post Link to post Share on other sites
HaNs 226 Report post Posted November 7, 2013 ^ do those come in wide enough sizes to do the roof lining? Lovely work btw, EDIT: scratch that, just noticed the 1.5m width, wouldn't be enough Yeh they do. The roll is 1.5m wide x what ever you want http://www.retwine.co.nz/products/P282-headlining-foam-backed-150cm-black I found the best thing to strip the old glue of the backing(card/roof) is CRC gasket stripper. Paint stripper doesnt do jack sh*t to the glue they used! Quote Share this post Link to post Share on other sites
HaNs 226 Report post Posted November 13, 2013 Still think it has a vac leak, sounds like its around cly number 5. Have cleaned out the ICV and checked all hoses, cant get it to increase revs with flamable sprays...any ideas before i rip the manfold off? Quote Share this post Link to post Share on other sites
