HELLBM 1557 Report post Posted March 28, 2010 (edited) M52B28 crank & front seal collar M20B20 rods M20B25 short block incl pistons $580 or individual parts buy request Only six kits avaliable. Rings,bearings,gaskets all avaliable from Gavin @ Euro-Italian Edited March 28, 2010 by HELLBM Quote Share this post Link to post Share on other sites
Silver Fox 43 Report post Posted March 28, 2010 Go Ray, still the best prices in Auckland. Quote Share this post Link to post Share on other sites
Nobimmer 694 Report post Posted March 28, 2010 Sooooo tempting. Must.Not.2.8! Will be in touch when the brakes are done. Quote Share this post Link to post Share on other sites
APT 195 Report post Posted March 28, 2010 You have got a PM !! Quote Share this post Link to post Share on other sites
pureboiracer 0 Report post Posted March 28, 2010 is it costly to get the 2.8 crank into the m20 block or is it a pretty simple job? Quote Share this post Link to post Share on other sites
Forrest 35 Report post Posted March 28, 2010 Have a search Oli, there are heaps of threads on here, including one I made, and plenty on overseas forums. Quote Share this post Link to post Share on other sites
c.robertson00 11 Report post Posted March 28, 2010 IIRC you need tha spacer for the oil seal on the front of the crank and the skirts on the pistons need to be trimmed down abit then be balanced Quote Share this post Link to post Share on other sites
1rotty 40 Report post Posted March 29, 2010 I discussed this possibility with Glenn a while back-can turn in to an expensive exercise to do properly Quote Share this post Link to post Share on other sites
APT 195 Report post Posted March 29, 2010 I gave Ray a call and it does look to be expensive especially if you cant build your own engine Quote Share this post Link to post Share on other sites
Mark 178 Report post Posted March 29, 2010 DCH Motorsport in Chch do a drive-in drive-out 2.8 conversion for $7000. That includes the fully reconned 2.8 M20 and ECU upgrade/tune. So yep, it's expensive unless you're awesome at rebuilding engines. Quote Share this post Link to post Share on other sites
APT 195 Report post Posted March 29, 2010 Guess thats out of my budget Quote Share this post Link to post Share on other sites
1rotty 40 Report post Posted March 29, 2010 Guess thats out of my budget Ha yep thats what I said. Quote Share this post Link to post Share on other sites
HELLBM 1557 Report post Posted March 29, 2010 Cost my son about 1100-1200 to convert his M20B25 into a 2.8 stroker. All I donated was the crank and M20B20 rods. That included shortblock assembly by paramount engineering. Do your math around that and you come in comfortably under $2000. Pistons did not need to be altered. At $7000 the chch. place is making a shitload. Quote Share this post Link to post Share on other sites
Driftit 2080 Report post Posted March 29, 2010 It is a cheap and simple conversion. It is best to start with a 2.5 block. Then all you need is 2.8 crank with spacer and shortened (very easy) B25 pistons B20 Rods stock rings, bearings and anything else you want to do. 1.3 Motronic ECU and loom Reflash ECU by Gavin at Hi Velocity. So if you are starting with a 325. You don't need much. Once the crank is adjusted you just rebuild the motor as normal. Quote Share this post Link to post Share on other sites
