Jump to content
Sign in to follow this  
skidz

E36 and E30 parts for sale

Recommended Posts

Have the following E36 parts available, pick up preferred

M50 engine, possible damaged head, good short block, sump etc $100

M50 Black Plastic cam cover, $35

A few other sundry bits and pieces also

E36 sedan rear bumper, blue, good order $30

Have the following E30 parts available, pick up preferred

complete 2.7 short block, hi comp, $250

M20 320 facelift block, crank, rods, pistons etc $100

M20 320 731 head complete with valves, camshaft etc $100

M20 sump $75

Right Front Guard, $30

Drivers door (sedan) $30

Front plastic undertray for M20, $20

set 4 14" basketweaves, $200 SOLD

Good 325 crank $50

Facelift rear seat, gray, $20

Facelift sedan door interior panels, blue $20 set SOLD

Facelift rear bumper, red, $30

Interior consoles, (front and rear) $10 per piece

Front and Rear ashtrays, $10 ea

Cheers...Stephen

Edited by skidz

Share this post


Link to post
Share on other sites

set 4 14" basketweaves, $200

Facelift sedan door interior panels, blue $20 set

Interior consoles, (front and rear) $10 per piece

Cheers...Stephen

hey there are the centre console and door cards(panel) have the spaces for the windows switches or was it out of a e30 with winder windows, i need the ones from a e30 with the winder windows(non electric) and aret hey leather

its a long shot but do you have a M20 Manual flywheel for sale i need one for my manual conversion for my e30

thanks Gareth

Share this post


Link to post
Share on other sites

complete 2.7 short block, hi comp, $250 <---- apart from a head and sump, what would this need to get running?

Share this post


Link to post
Share on other sites

complete 2.7 short block, hi comp, $250 <---- apart from a head and sump, what would this need to get running?

Umm, the rest of the car? Seriously though if you have an M20 motor (320i 323i, even a 325) you can swap this short block over.

Edited by skidz

Share this post


Link to post
Share on other sites

hey there are the centre console and door cards(panel) have the spaces for the windows switches or was it out of a e30 with winder windows, i need the ones from a e30 with the winder windows(non electric) and aret hey leather

its a long shot but do you have a M20 Manual flywheel for sale i need one for my manual conversion for my e30

thanks Gareth

Have several centre consoles, have with no holes for electric switches, two holes or four holes, take your pick. The door panels , the rear panels have the switches still in them.

I may have a flywheel - I will check later.

Share this post


Link to post
Share on other sites

I'll take the blue door cards if they're in good nick. I'll just have to figure out how to get them to Hamilton. Hmm, Dutchy?

Share this post


Link to post
Share on other sites

Have several centre consoles, have with no holes for electric switches, two holes or four holes, take your pick. The door panels , the rear panels have the switches still in them.

I may have a flywheel - I will check later.

Sorry, cant locate flywheel, but i do have the clutch lever you were looking for

Share this post


Link to post
Share on other sites

Excuse my ignorance, but what is a 731 head for a 320i?

Share this post


Link to post
Share on other sites

731 is the casting number for a E30 320i head, 885 for a 325i head.

Share this post


Link to post
Share on other sites

I'll take the blue door cards if they're in good nick. I'll just have to figure out how to get them to Hamilton. Hmm, Dutchy?

OK PM Me

Share this post


Link to post
Share on other sites

which m50?

Is 325, from 1995 coupe

Share this post


Link to post
Share on other sites

Bump, more stuff I have found:

E30 323 fuel pump relay, $10

E30 standard steering wheel, good condition $10

Kick panel for under dash $20

Left facelift tail light $40

Facelift header tank $10

Lots of other E30 stuff

Share this post


Link to post
Share on other sites

will take that facelift header tank will contact you sometime next week about picking it up...

oli

Share this post


Link to post
Share on other sites

how much to ship the 2.7 block to chch....

You need to find someone to come pick it uip - Mainfreight do door to door

Share this post


Link to post
Share on other sites

will take that facelift header tank will contact you sometime next week about picking it up...

oli

OK

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...