E39 Aux cable

[AlexWill 0]

Hey,

I've been thinking of putting an aux cable into my 2000 BMW, been searching the web on ways to do it... with not much luck, does anyone know who can install one for me or ways i can do it myself? preferably DIY as i would assume getting someone to do it would cost a fair bit, and as I'm in the final stages of my studies I am on a pretty tight budget.

any help with this would be much appreciated.

Thanx

[Neal 540]

Need a bit more infor on your system. Do you have a cd player / stacker / Nav sat , or head radio / tape / Cd.

depending on what is install will depend on Aux input (normally late 2002 devices on)

At a guess your best option maybe a device that plugs in where the CD stacker connects which gives AUX / Ipod.

[AlexWill 0]

I have a CD stacker in the boot, and a tape player by the dash with the radio, I'll upload a picture of the set up in the dash, may make it a bit easier.

[westy 614]

I just tapped into the cassette pre-amp behind the deck up front.

[AlexWill 0]

comes up with this error when i try and upload the picture, any idea who i need to contact for this to be fixed?

Upload failed. Please ask the administrator to check the settings and permissions

[AlexWill 0]

think i managed to find a way to post it

[Neal 540]

I don't believe that your tape player has aux in. ( can anyone else confirm ?)

The tidy way is to get a audiovox dice device that sits between the Cd changer. It gives you iPod, aux in , sd card and optional Bluetooth connectivity. Steering wheel controls work etc. you'll need to run the wiring from the boot to your console.

The other way is as mentions above which is to mod your tape player. http://jcrowell.info/bmw-aux-in.html

[hybrid 1043]

As westy said, remove headunit, open it up, solder to line level inside the unit a mini jack cable.

Done

[westy 614]

I wasn't even that fancy (surprise surprise).

My Cassette sends its preamp to the back via 4 wires. I just cut and shut those with a jack cable.

It's a TV thingy radio though. Only real downside is, it's a bit quite. Obviously a lower level output from Ipod compared to Cassette.

[AlexWill 0]

Thanx, will give the soldering a try, are some of the images broken on your computers too on that link you gave me? Only 2 are broken but the rest i can see, and gives me the basic idea of how to go about it.

So westy, if i had to do it this way would it be a lower output too? or is it they way you did it that gives it a lower output?

[westy 614]

I would expect so.

[RustyItalian 11]

Only hitch with the 'tap into the cassette output' approach is when you have a faulty tape deck (as mine is). The tape deck stops the signal input to the amp (somehow) when the tape deck faults.

The integrated entertainment system in these cars is a pain in the arse.

[AlexWill 0]

Yea its not too great sound quality wise, doesn't sound very crisp, but I would assume its cause its mono sound since its going through the tape player? may be wrong?

but it will do for now, till I finish my studies and start work again to afford something better, after a while one gets use to the slight static noise it produces every now and then... Was easy enough to do than what I expected it to be.

Now the next project I'd like to do on my car is get the mags and calipers painted

[westy 614]

Na, it's stereo. Sounds like sh*t cause the system's sh*t ha.

[AlexWill 0]

Na, it's stereo. Sounds like sh*t cause the system's sh*t ha.

ah fair enough, may just have to put up with it till I get a new stereo, was looking at something like this

http://www.trademe.co.nz/motors/car-stereo...n-528182640.htm

Do you know if this is any good?

[Tristan 338]

Now the next project I'd like to do on my car is get the mags and calipers painted

Hi mate,

This may be of interest to you. $60 and an afternoon in the sun.

Wouldn't be using it on calipers though.

http://www.bimmersport.co.nz/forums/index....showtopic=42337

Edited October 29, 2012 by Tristan