duluth 41 Report post Posted July 9, 2020 Hi everyone , recently been experiencing some rough shifting, loss of low end torque and a rough idle.Replaced the DISA O ring and this remedied these problems to a certain extent however yesterday my transmission light came on and went into limp mode, the one that doesn't go away. Scanned the car with the INPA system and retrieved these codes from the engine : 125 Activation Electric Fan (i dont have an electric fan) 90 Exhaust Temperature Pre Cat Conv – Bank 1 91 Exhaust Temperature Pre Cat Conv – Bank 2 93 Exhaust Temperature Post Cat Conv -Bank 2 63 DME Control Unit or Ambient Temp Signal via CAN (MS43) I also pulled these codes from the transmission: 59 Knock Sensor -Bank 2 (this has accured 12 times apparently) 65 Camshaft Position Sensor (Inlet MS43) The transmission failed previously at 213,000kms but got it fitted with a lower km trans. Car is now at 219,080. Any ideas on if the transmission has already gone bad or something else at fault which is sending the car into limp mode. Sorry for the long post , any help is appreciated, cheers. Quote Share this post Link to post Share on other sites
BM WORLD 1283 Report post Posted July 9, 2020 cam sensor can sometimes cause that Quote Share this post Link to post Share on other sites
B.M.W Ltd 950 Report post Posted July 9, 2020 Take into Jon at Auto38 in Wellington and get it scanned properly 1 Quote Share this post Link to post Share on other sites
Olaf 3317 Report post Posted July 9, 2020 yep. proceed straight to Auto38, do not pass Go, donot collect $200. Unlike Jail in Monopoly, Auto38 is your best Independent in Wellington. BMW Car Club NZ membership benefits too, on production of your card. Quote Share this post Link to post Share on other sites
