Search the Community
Showing results for tags 'loom'.
Found 3 results
-
I am looking for a full bmw m50b25tu VANOS engine loom. Live in Auckland region can travel or pay for shipping. Thank you.
-
Interested in doing converting my m20b27 to motronic 1.1. So I need the following parts: Crank Position Sensor & Bracket Toothed crank wheel Engine bay loom Cylinder Identification Sensor Oil Level Sender Oil Pressure Switch And probably an ECU, but I haven't decided what I'm doing ECU wise yet
-
Hi Guys, So iv got a fully dressed '87-'88 M20B25 with loom and ecu, gearbox etc all with it lined up. The only problem now is the wiring from the C101 plug which is round and has 20 pins, to my rectangular C101 on the '85 323i. I have started to create a pinout chart which ill upload later tonight, theres just a few wires i am unsure where they should go? There is scarce information about 323i's on the internet, as they were Euro spec and well you know, if its not US spec then no one on any of their forums wants to know about it. I also need a bit of help as to what will go to the C104 plug (i understand this is for the cluster side of things). There is a round connection on the bulkhead by the passenger side, i know this isnt a C101 as i have an earlier car but i was wondering what it actually is. Any wiring help would be much appreciated. Ill upload my chart so far later on. This is the first time iv done anything near this intense mechnically, but thought id try my hand at it. I havent got the engine yet but will have it in a month, so i thought its best to prepare everything now so that its easier when i have everything. The 323i L-Jet wasnt the best starting place but its what i have to work with so ill do my best to make it work. If any of you guys are around Central/West Auckland, and know about the wiring id be real keen to have some help when the engine is dropped in. i HATE electrical systems and having not much experience doesnt really help my cause. Im sure with some help i can get this done successfully, so cheers for any help you can provide me with! Also i know the connector changes around the time this engine was built, so i will check again and confirm. This will probably be the same thread i ask lots of electrical questions over the time of the swap. Thanks!
