Greg111 13 Report post Posted March 22, 2012 (edited) So after thirsty thursday pub time i thought it would also be a good time to remove the manifold off the V8 to replace the pcv valve (cheers for the fast delivery Lance, top man), no the manifold doesn't need to come off to do this but i have my reasons, anyway i found this just chilling out in one of the ports: Don't ask how it got there but glad it ended there. Edited March 22, 2012 by Greg. Quote Share this post Link to post Share on other sites
Neal 512 Report post Posted March 22, 2012 Wow , that could have ended up real bad ! Quote Share this post Link to post Share on other sites
allan 295 Report post Posted March 22, 2012 was it plastic or metal Greg Quote Share this post Link to post Share on other sites
Greg111 13 Report post Posted March 22, 2012 Just a plastic trim clip, obviously not quite hot enough in there to melt it. Quote Share this post Link to post Share on other sites
*Glenn* 854 Report post Posted March 23, 2012 Don't ask how it got there but glad it ended there. I have to ask.... HOW???.... man up Quote Share this post Link to post Share on other sites
Michael. 2312 Report post Posted March 23, 2012 Whats the thread like material running off it? Quote Share this post Link to post Share on other sites
*Glenn* 854 Report post Posted March 23, 2012 Whats the thread like material running off it? Thats what I was wondering... you stage this Greg ?? Quote Share this post Link to post Share on other sites
1rotty 40 Report post Posted March 23, 2012 sh*t..thats where that went !!!!!!!!!!! Quote Share this post Link to post Share on other sites
Ahmedsinc 414 Report post Posted March 23, 2012 Correct me if I'm wrong but doesn't exhaust gas temp range around 200 - 600 odd degrees centigrade at the ports? How on earth did that not melt into plasticky goo and run into the cylinder? Quote Share this post Link to post Share on other sites
Greg111 13 Report post Posted March 23, 2012 I have to ask.... HOW???.... man up Ha, you got me there, the air flow meter has a grate across it so it couldn't have sucked it up, by the looks of it, it's been apart before.Whats the thread like material running off it?Dunno, didn't see that when pulling it out, it was wedged in. Not even a genuine clip either....pffft!Not sure what sort of plastic it is but the engine has coolish air runing through it all the time plus the coolish fuel getting sprayed directly onto it so it must have been enough to keep it in form. Quote Share this post Link to post Share on other sites
