Leaderboard

Does this particular E34 happen to be deregistered? If so, SJ sold that very quickly o.o

I am sure he needs no introduction. RIP http://www.motor1.com/news/128783/obituary-paul-rosche/

i run over 11/1 on turbo eth setups, 9:5/1 is fine and will be also if you run pump 98 so dont stress 875 is way to small for eth try ID2000 they will also run fine on pump

Rear shocks are easy, shouldn't need spring compressors? I've never used them anyway. Undo top bolts, jack under hub, remove lower bolt, replace shock.

More room for Aston Martin mufflers!

Nice buy - I saw that on facebook and would have loved to pull the trigger but life just isn't in the right place. Good on you for taking up the challenge!

I built a 6 x 7 total span at my place about 7 years ago, all up was around 30k, I got someone to do the slab and I did the rest. I had to get a fire engineers report because I was close to the boundary, as well as a survey to check the boundry. I also had to get an engineer to do a PS 4 because I built it myself (about $500 from memory) I have one of those wind powered ventilators so no condensation issues, but it still gets hot in summer. I also increased the wall height to 3m so I could have a gantry beam running across with a chain block for lifting engines etc. I also spent a lot getting power put in, I have 20 x 10 amp plugs, 1 x 15 amp, and 1 x 32 amp for my welders. (Still not enough!!) Inside is lined with 12mm ply so I can attach stuff to walls, and it is insulated with noise stop batts to keep the neighbours happy! Have fun!

so on the weekend I chopped out some fat. To be fare was only 8kg'ish. But when adding new parts a balance has to be found. note the extra room for the diffuser.

Yes, the most difficult thing for me is that I can't drive it either...