andyb184

I am looking for a black leather rear seat bench (upper and lower) for a sedan in decent condition. Wellington region only please. Thanks guys

no, the real diamond key has the transponder (10030A ELMOS) attached to the circuit board.

Dogballs is correct, the transponder doesn't care what key blade it belongs to. The only drawback is that you are sacrificing a key to make another key.

thanks for chiming in Gabe... also, as far as the part# and 315Mhz or 433Mhz freq.....it doesn't really matter which one you'll get, especially with most cars coming from Japan. What's more important is, do you have a bmw business radio or similar and wish to keep full functionality? In that case you'll need 6907123 (433 Mhz) or 6907124 (315Mhz) ...again your choice

this whole thing is called volute spring (I01002, X01003). Best to look up the pinout at http://www.bmw-planet.net/diagrams/release/us/e46/index.htm Essentially, the left plug feeds the airbag, the right one (blue,grey, wht, red) the cruise control buttons. You might have to tap into the green main connector that plugs in from behind the wheel (X10170). Good luck.

here the official recall notice if anyone is interested.... E46 Airbag TSB.pdf

E46 sedan tail lights (pre-facelift), no cracks, great used condition. All bulbs included. $80 shipped 63218364921 (rear light left) 63218364922 (rear light right) 63218364923 (trunk lid, left) 63218364924 (trunk lid, right) Thanks for looking.

Is it yel/bl or yel/gr now?

I found only one Yellow/Green wire and it wasn't going to the Transmission control module (blue) as it seems here, but the DME (black module). Last 7 of your VIN please to help is identify your tranny? Thanks, a.

pull that big plug connector going to the ABS/DSC control module and trace those 2 wires...it's hard to say without knowing the exact color codes as Will mentioned.

http://www.bmw-planet.net/diagrams/ ...some work

pm sent. Thanks

pm sent.

you got it Graham, pm sent.

Front right turn indicator/clear - Bosch #63136902770 used/good condition w/ bulb $15 shipped Low beam cover caps - OEM #63126946039 used/good condition $20 shipped Upper Seat Belt - Front Left & Right w/ Force Limiter #72117009857 #72117009858 used/good condition $50 shipped Fuel filler cap - OEM #16117193372 brand-new item / fits a multitude of BMW Fuel filler cap - Genuine Blau #16117222391 brand-new item / Fits a multitude of BMW $15 shipped/ each

SOLD, Thanks bought this drive belt/pulley set a while back and never used it, fits a multitude of BMW (320i 323i 325i 328i 330i). 2 belts (serpentine and AC compressor belt) 2 tensioner pulleys 1 idler pulley $80 shipped anywhere in NZ Please pm me of you're interested Thanks

this is an easy enough DIY and will take you only about an hour to do. If you are not comfortable, find a buddy that can assist you. But it's literally 3m of two-wire cable, some zip ties, and using 2 quick splice connectors - a lot less wiring than any other aftermarket solution. Any technician would be waste of money as they would simply follow my outlined instructions and in the end not even warranty their work. Everyone on this forum has been in a similar situation and will provide help as you can see.

OEM 64116956319 Item is in used but good working condition, no scratches. $80 w/ shipping thanks for looking, a.

just out of curiosity, what did you find out?

you are wrong, the clown nose contains two LEDs from factory. The IR receiver is inside the mirror. You can carefully pry it out with a flathead screwdriver and pull it off. There are 2 reasons why it doesn't flash: it's probably not wired to the General Module. Second, you need to code your car and set DWA (Alarm system) to active. Here is what you can do to see if it's pre-wired: Unsnap the mirror plastic cover and pull the plug connector to see if there is a wire at Pin# 9. I think it's grey/black with thin yellow marks. This runs to the GM5 (X254 / 26-pin, black connector) Pin# 23 and feeds the LED. as an example, in the picture below the wire is missing....

from my experience the inclination sensor will not go off when you bump the car, not even when you push down on a corner. Only if you raise it with a jack.

how much for a set? pm me. thanks

updated price

E46 Headlights, pre-facelift 63126902747 left 63126902748 right great used working condition, all dust covers and bulbs included. $80 (+ Shipping) or pick-up *************************************************** E46 Tail lights, pre-facelift 63218364921 Rear light left 63218364922 Rear light right 63218364923 trunk lid, left 63218364924 trunk lid, right great used working condition. Bulbs included. $60 (+ Shipping) or pick-up

That's correct. You need to figure out which one is Key 1, do that one first and then all others. Otherwise it won't hold the sync.sent from my android