WTB: BMW 130i manual

[gofaster 101]

Hi. Just putting feelers out for a 130i manual.

Looking for something similar to what Scott Harvey had (or still has) for sale recently. Tried contacting him, no reply so assume sold.

Dont mind the higher mileage if the maintenance has been done, been reading here about solenoids, water pump, coils and some gaskets.

I'm  not in the $10K plus price range.

Thanks, John

[NZ_InFerno 371]

Pretty unlikely to get what you're after for less than 10k, unless you go for an  automatic. 

Even then you'll still want a grand or two to fix any issues or at the very minimum to buy a scan tool to go with the car. Which will save you time/money fixing issues. 

 

[gofaster 101]

Thanks Inferno. I was kinda hoping Scott's one was still available as it fitted my budget although offset with higher KMs. Will keep looking...

[M3AN 4016]

Did you see the $10k one in Auckland? I doubt you're getting a manual for less than that.

https://www.trademe.co.nz/a/motors/cars/bmw/listing/2724085311

 

[gofaster 101]

Yep, saw that and the $12k one with some work done.

End of day they will likely owe me $12k, so out of budget.

May have to bide my time or look for something else.

thanks for your comments,

John

[gofaster 101]

Have any of you guys in Auckland viewed the 130i that has been on Trademe for a while now?

Or know the previous owner.

Be good to hear any feedback, I am based in ChCh so only option next would be an AA inspection

Thanks, John

https://www.trademe.co.nz/a/motors/cars/bmw/listing/2724085311

 

 

Edited November 20, 2020 by gofaster

[M3AN 4016]

I have no knowledge of that car or its provenance sorry but for less than 10k it's probably worth a look.

I don't think an AA inspection is worth the paper it's provided on, I'm not even sure if they hook it up to a scanner these days. If I couldn't find a trustworthy independent nearby in Onehunga I'd probably consider getting it checked out by Auckland City BMW but I think you're in for $130 IIRC. Somebody else may have a better suggestion though.

I can tell you at first glance that the rear wiper either doesn't work, or is about to fail (common problem).

I'm not too far away and if the moons aligned could probably eyeball it for you any even plug it in if they let me take it for a proper drive but I certainly don't offer any warranties! A lot would depend on how my schedule played out over the next little while.

Maybe if nobody else around here knows the car or has any suggestions send me a PM and we can go from there. No promises. 

[Jacko 2158]

Dont know it either, interesting spec though. Msport with walnut etc. Im going through onehunga Monday, If I get 5m ill go take a looksee.

[gofaster 101]

Thank you M3AN and Jacko.

Appreciate any looksee or observations.

Will PM you

[KwS 2429]

The panel gaps around the front bumper look on the piss, so be worth checking for damage in the front.

[Jacko 2158]

Tow hook cover at the front missing too, looks like might be BMWP exhaust tips. 

[leichtbau 525]

55 minutes ago, KwS said:

The panel gaps around the front bumper look on the piss, so be worth checking for damage in the front.

To be fair, most 1 series have awful shut lines around the headlight and bonnet area!

[KwS 2429]

1 hour ago, leichtbau said:

To be fair, most 1 series have awful shut lines around the headlight and bonnet area!

Im thinking more the guard/bumper gap, which on most 1 series is big, but you could almost fit a foot in the gap on this one. 

[leichtbau 525]

Yea that looks like broken slides for sure.

[Blackie 510]

[Jacko 2158]

Painful getting pics up here off phone @gofaster but heres a run down on it and pic dump (have more and a couple of vids (tick before and after) if you want anything specific)

Its a straight car, no obvious accident damage or evidence of a respray. The front bumper and the gaps are due to the previous owner trying to rip the bumper off on kerbs... 

Paint looks like its been washed with a steelo, but its not deep. Few minor stone chips but nothing bad, its just every panel is dull with scratches. With a solid cut and polish it'd come up shiney.

Lots of evidence of UV damage - headlights, rubbers, rear badge etc... but nothing end of world or not fixable. Bonnet release cable feels stretched, really got to yank on it. 

Interior is OK condition, bit battered, it needs a massive clean and tidy up but it'd tidy up OK. Headlining is falling down at the back. Looks different (and is pretty rare) in this spec.

 

Front end feels very loose (it might just be stock vs mine though as  it was back to back test), I suspect a flogged bush or two, and there are tell tale signs of dicky alignment. Tyres are bridgestone RFTs, the same ones all the jap imports have and all look old (probably came from japan with em). Front right wouldnt pass a warrant due to inner camber wear

Brakes look old, but work fine and feel good, lots of rotor life left. Steering reservoir is leaking bad. Shocks look original, but all the suspension parts look clean and still have BMW p/n stickers on em.

 

Battery was dead flat when went to start. Engine had the worst lifter tick I've ever ever heard which was a little concerning, however it went away after an italian tune up which is good. I suspect its been sitting for a long time.

Engine has all the classic oil leaks, other than the sump (or if it is leaking the sump is minor), rocker cover gasket is toast and so is the oil filter/cooler ones. They have been toast for awhile and its made a mess (and smells oily after above tune up)

Has green coolant in it (horror!), and it was a smidge low. Clutch feels good, if a little light (might just be my memory as mine is a SMF etc), DMF and release bearing are silent, and engine feels strong. Shift action is pretty good, no obviously flogged bushes. Engine sound deadening is dead...

Engine pulls well and sounds good though. 

 

Exhaust sounds nice, not to sure whats done to it, tips arent factory but muffler looks factory. 

 

With some love it'd be a nice car, but it'll take some love and coin to get it there. I suspect it was mint in 2014 when it came out of Japan and has been a bit neglected in NZ by the previous owner (its a trade in). It might be worth trying botany BM workshop to see if they have any service history. 

 

If it was my project -

• Waterblast the f**k out of it, lots of pollen and dirt (and spiders) everywhere.
• Full cut and polish and birthday with new bits (like BMW badge at the back, its sad!) 
• Clean up interior and stick roof lining back up
• New tyres
• New front end bushes, shocks and an alignment
• Every single oil gasket on the engine. New belt/idler/tensioner as they will all be poked due to the oil leak(s) (and the belts like to be ingested by the crank when they go!)
• New waterpump and thermostat, full coolant flush.
• Probably new starter (its at the K's where starters fail) and a new battery
• Sort the O ring on power steering reservoir

 

 No warranties given, your mileage may vary, wash rinse and repeat if necessary

Edited November 23, 2020 by Jacko

[NZ_InFerno 371]

Top man @Jacko

[gofaster 101]

Big shout out to Jacko for taking time out to look at the 130i and provide such thorough feedback.

Managed to negotiate a price and have secured the car

Have a list of jobs to do over Xmas, will no doubt be asking some "how to" questions on the Forum

Cheers, John

[Blackie 510]

?

[NZ_InFerno 371]

Hope you got a good price, needs at least 3k in thrown at it 

[Jacko 2158]

It'll be a good start to a project car, it appears to be straight and honest just needs some love.  Elbow grease, a DA,  and swinging of a spanner will solve a lot of it pretty simply. With things like the tyres/shocks they just become good excuses to upgrade!

Reality is half the 130s out there selling for over 10k will have the same faults, just owners that are none the wiser. Should do an experiment, run around all the 130s in dealers yards and look for oil leaks and green coolant. $50 its more than half of em  

Edited November 24, 2020 by Jacko

[Jacko 2158]

30 seconds with a 13mm socket.

Anyone have record of what the P/N is thats stamped on the BMWP muffler? It might be a BMWP unit, sounds tougher than mine and Y pipe on it looks factory. 

[Blackie 510]

It could be the exhaust leak?

[leichtbau 525]

3 minutes ago, Jacko said:

30 seconds with a 13mm socket.

Anyone have record of what the P/N is thats stamped on the BMWP muffler? It might be a BMWP unit, sounds tougher than mine and Y pipe on it looks factory. 

18 10 0 443 576, 18 10 0 208 802 was the supersession.

[M3AN 4016]

1 hour ago, Jacko said:

Reality is half the 130s out there selling for over 10k will have the same faults, just owners that are none the wiser. Should do an experiment, run around all the 130s in dealers yards and look for oil leaks and green coolant. $50 its more than half of em  

Good community work Chris, thank you.

And I agree 100% with the above, that was exactly my purchasing experience. All 10-14 year old cars require about the same investment unless they are unicorns.