Leaderboard

Great after half a day of gardening 50 min at 60C and 100% intensity bathed in golden lighting and listening to my favorite music which would not interest most on here. Then a very luke warm shower and nice clean fresh clothes. Every second day for both of us... the sauna, not the clothes ?

E9x M3 rear control arm retrofit into the Hellbm 140i E87. Replacement of the 135i upper arms with M3 ones should tighten up the rear.

Hello Guys, I'd like to share some photos of my first ever bimmer, an E91 335d.. Best daily so far! I'm based in AKL and has finally managed to have some free time go through the forum.. Already found heaps of awesome stuff & supportive forum members so far... Hope to find some more DIY tips to keep me busy over the lockdown period and share some as well. - Andrew

Probably... so long as your wife doesn't mind smelling like a spray booth

Gives a deeper note with improved performance. Post cat Oxy sensors coded out. Available $750 includes fitting and tune. Jig made for the production line.

Cup holders looked a little bit dirty, and there was a dog hair stuck under the passenger seat... Might pull the windows out next week to clean em

Best Appliance/tool I have ever purchased in my life. Dimensions are 825mmW X 890mmD X 1690mmH. 6 individual infra red heating panels with magnetic wooden safety panels. Max operating temp 65C Bluetooth sterio speaker system with internal lighting. Chromotherapy lighting system (sold separately) yet to come next week sometime. Easy fit into the roof. I put this together yesterday. I'm absolutely rapped and impressed with the quality. Wife and I have both used it separately. I did 30 minutes at 65C set at 75% intensity. It was hard going first time and I'm going to use it at least every second day. Did I feel good after the shower ?

Whats your favourite music Glenn? Its ok, you are among friends here.

I believe there are two different sizes, depending on the input shaft diameter, so it depends on if your input shaft is 12mm or 15mm. The outer diameter is the same, and the thickness doesn't matter too much. Just measure the input shaft diameter of the gearbox you are using and order the bearing to suit that. Make sure you get the bearing installed at the correct depth too.

Fair enough mate, hate it when life gets in the way of hobbies haha

Have had plenty of garage time and as I’ve explained to wife it’s dangerous to climb ladders currently with risk of broken bones and catching Covid19 at the hospital ? Ticking off items on the project list. Clean, paint & rebuild brake callipers Used a combo of wire brush, electric drill with wire brush attachments, dremmel wire brushes, sand paper and brake cleaner. Painted with 4 coates of Duplicolour Calliper paint and 3 coates of high heat clear over top. Blue’s my fav colour. Decided not to use MSport logos as I would have had cover up the MSport stamp on the callipers. Used ATE ex-FCP Euro seals and followed instructions placing dust shield at bottom of piston before pressing in using g-clamp. Straight forward. I’m really pleased with the results. Moving to the rear. More corrosion here and pistons were a little seized! Plus the pads had disintegrated!, Looks like a BMW stamp? So need to get replacement pads. Supercheap and Repco online is available. Anyone make any recommendations for the brands stocked? XP dba, Reco brand, TWR or Silverline? May end up being stop gap. Also replace gearbox mounts Straightforward loosening top nut then using jack to take weight then dropping gearbox bracket a bit then remove mounting nuts top and bottom before sliding out. Install the reverse.

Week 1... Making it shiny. Might be going crazy. Soft99 KoG over top of Fusso 12.

Good for drying painted parts?