Hey Team
Happy new years
Been a while but have got so much done and a few plan changes.
Certifier has popped in, seen the drive shaft hoops and he is happy with the outcome.
Heaps of little jobs done to get the motor finally running.
Relocated the heater water valve, DIY oil catch can, relocated dip stick, welded O2 sensor bungs in, coolant and heater hoses, finished off the rear end of the exhaust, AC lines and other small stuff.
So I have had the motor running on the hoist for a good 10- 15mins to bring up to temp checking for any leaks or issues.
But ran like a dream, custom oil pump has pressure so very happy it has worked out. Cant wait to take it for a drive.
Also a massive update on the v12 swap, Nelson at Hartley Motors has started on the intakes using 3d printing to make the runners which will be glued to the alloy flanges, very light when I held them in my hands and look very cool.
But big changes in the direction with the builds now ( I know I change my mind quite often)
I'm going to twin turbo the v12 motor now instead of ITB's and I will be swapping the v12 in to my X5 4.6is manual.
The opportunity popped up which I thought would do more justice for the M3 rolling body.
I will be doing a S85 v10 manual swap into it Cant wait to get a start on this swap.
Thanks Team.