BM WORLD

they have a tag with part numbers and ratings on them . smaller size will be 90amp

sticky idle control valve (icv)?? faulty old worn out PCV crank case vent valve. spilts in intake boot or some othe rac leak etc. all thes ethings will cause rough idle , stalling etc. faulty heater tap valve will stop hot water going through the heater system. or air locks in the coolant system, force water in with a hose while the bleed valve is open so it lets the air out or the system.

have this undamaged shell , reg lapsed a few years ago , has had the front and rear subframes unbolted from underneth. no seats or door cards , still has dash , key , windows , cluster , carpet ,no suspension ,or steering rack etc. so would be easy enough to rereg it etc. maybe suit someone with a bent car but good ruuning gear etc . single or non airbag type etc so basically a shell with doors and glass say $400 or it goes to scrap minus a few more parts . in drury for collection 021433600

new plates , wof and reg on the 98 750il . needed new front brake discs and pads. adjust rear handbrake shoes. new thrust amr bushes , tail light bulb holder and sort the rear left adjustable head rest. new oil and filter , 2 new air filters , coolant and brake fluid change. regassed the aircon drove it around today , goes well , very quiet and smooth , filled up the tank $192

love the chilly bin full of ice in front of the intercooler at 2:15

nice but wrong interior in my books , should be black leather etc

bump any takers , offers. would be a good car when sorted . still has wof and reg paint and panel work in fairly good order. also have 5spd conversion kits , 325i 328i engine kits etc

put the correct type in as the plugs /pins are different

yup why not

have these ones listed ,not sure if that helps 1363 1273 277 will double check the numbers later

can do some spacers for you.

may have something to suit . maybe even brand new one. do you have the part number or picture etc

some details here. http://www.bimmersport.co.nz/forums/index....showtopic=31734

another one front view . check out at about 7min 30 sec.

yea seen it done before though i would try it . yea sorry about the quality , the sd card ran out of space in my still camera so that was the last bit i recorded on low quality to just get a bit more track time in. have more higher quality stuff to upload but takes so long. also had a little go pro or someting like that facing forward recording as well , will uplaod some of those later too. higher picture quality but poor sound not sure on the lap times yet , will study the recordings and take times etc. spent a few laps just following mates so they can see footage later etc..

filmed out of the rear screen in my e28 m535i turn up the volume will upload some later

broken wire inside sender drivers side. resolder it back on

3.64 and 3.73 are comon ratios. installed in those you choose what you want i have a 3.91 lsd for one and a 3.25lsd use this to work out your revs at speeds etc http://members.dodo.com.au/~wawawa/revs.htm

look nice and clean oner of these will fix your bumper http://www.trademe.co.nz/motors/car-parts-...n-564382080.htm

worn out air flow meter , vac leaks ,fuel pump had it , faulty fuel pressure regulator

worn out air flow meter , sticky ICV , vac leak . fix these things and they will normally idle nicely

yes go for a single mass flywheel and rebuilt stronger clutch setup. can use a m20 flywheel and starter or one of those after market flywheel clutch kits etc those wheels will work fine

i know where there is a mint set

you still looking have a 93 318is coupe . single airbag car 202k grey , still has reg and wof , just overheated , still drives etc. pretty tidy paint etc. good hood linning . have more pics if needed

has it got spark , pull one coil out plug in a spark plug , crank it over. these engines have issues with crank and cam sensors failing , poor insulation , breaks down from heat etc. easy to test the pump , remove , stick it in a bucket or fuel , hook up 12volts and see if it goes. listen for the sound it makes should be a nice hum , not crackly etc i have brought many cars that have sat for years and the fuel and pumps still work fine etc but i suppose could have got damaged if it was sucking air , they just burn out as they use the fuel to keep the pump cool