Leaderboard

Ended up with a 2012 30D. 1 owner from new (nz new) with 64k.

Under those circumstances I would consider that a set of four matching wheels of any type showed an unexpected degree of motoring sophistication for the Far North Cheers...

Did the hardest job on list - CCV and hoses, plastic water pipes and cleaning. Pipes were still in decent condition but new parts come with peace of mind. Couple of small bits of broken plastic to flush out later from the block, otherwise the heater valve may grab them for me.

Pffft... haven't you been up north? I was in Broadwood (north Hokianga) and an 80's RWD corolla went past... no doors and 4 space savers. Just cruising down the main road, like it was normal. The kid driving it was probably 12. Not sure if the other occupants were his much younger siblings, or offspring 🤣

Just saw a Falcon with no windows drive past. Hot, sunny day... is this bogan aircon?

The fact that the photos used in the listing looks like it was just taken from what he already had in his phone makes your statement so much more plausible 😂. Either that, or he’s a very very ‘laidback’ person.

@Sammo https://www.facebook.com/groups/792622097429141/permalink/4916151651742811/?sale_post_id=4916151651742811

The meth dealers must be making a killing lately!

2nd year with us service at BMW. WOF, 2 new rear tyres and alignment, $960 done for another year. To easy 😎

MTech1 in Heathcote Valley in Christchurch. 220kms, appears to live outside 😕 gorgeous colour and the urge to leave a note to buy is high!

Finished off the rear suspension - Trialing a set of TRW rear shocks which are suppose to be Msport equivalents (Sachs don't make any now days). RTABS + limiters - old bushings weren't as bad as i expected but are '02 labeled so probably the originals. Front struts done - old ones were completely gone as expected, the weight of a 19mm 1\2" impact socket would compress the piston to near bottom. I only noticed one of the strut towers was mushroomed upon strut removal, likely caused by worn struts and mounts combined with pot holes. Have hammered it flat and will be putting in some reinforcement plates before re-installing.