e30ftw

Anyone have an M52B28 MAF for a reasonable price?

Hmm true, wasn't aware it needed some bedding in. I replaced a whole bunch though, Coolant temp sensor, Intake air temp sensor, Cam position sensor, VANOS seals, Oil / Coolant change and cleaned out the ICV. It's idling better but seems quite sluggish. Knowing me I probably missed something somewhere..

Yep it did. Sure got me.. I've replaced everything now and went for a drive but it seems real hesitant now. Wasn't the improvement I was hoping for

Sorted it, I had only cut and removed the teflon outer ring on the old one, didn't notice the o'ring underneath it. Mine too slid right out, nice and tight now can't wait to see how it goes tomorrow

VANOS Seal reaplacement - On a single Vanos M52, I have the new seals. I don't really get what the Besian Systems write up wants me to do with 2 seals - It says insert the o-ring into the piston groove, then it says insert the Teflon seal into the groove. They don't look like they will go ontop of eachother or are they supposed to?? Help I'm half way through haha

Nah bought a spare set when working through my misfire issue, which turned out to be cam sensor / 02 sensors. This stuffs just spares / double ups.

Bump - Edited original post. Price drop on water temp sensor, added M52 Coils.

BUMP - Cam sensor sold, Coolant sensor take $30 shipped

BUMP, Take offers.

Not much help, but holey doesn't look like that's ever had an oil change. Your whole engine will be like that.

Yeah technically you need a cert. But VTNZ is pretty dum, didn't even notice my M52B28 in an e30. YOLO

$20 for M52 Water Temp sensor, Brand new. $80 set of 6x M52 Coils

Where about's are you? Some good suggestions here in a thread a few months back : http://bimmersport.co.nz/topic/46563-flywheel-lightening-where/?hl=%2Bflywheel+%2Blightening I ended up going with Howat Engineering down here, got it from 8.4 to 6.5kg lightened and balanced for $80

Any starter will fit the gearbox - Just need to match the flywheel with the starter so if it's an M20 flywheel that's what you need I have a spare one if you need one closer to wellington.

It's actually sitting T piped between the Intake boot and ICV line, so kind of inbetween the TB and ICV. So unless the engine is sucking alot of air through the ICV line not sure if it makes much of a difference. I may give it a go though and see how it runs like that.

I really can't think of any places there would be a vacuum leak, all the hoses seals etc are new. The only actual difference is I am not running the CCV system the M52 normally has, instead I ran a hose from the crank case into the intake like an m50. One thing I notice, If I take the oil cap of the engine while running, the idle turns really rough (simulates a vacuum leak?), When I put it back on, it idles perfectly again. True I actually have a new water temp sensor I never installed. Slipped my mind, But I guess that will make sense if the ecu thinks the engine is still cold and runs it richer.

Vodafone finally set us up after a month, Cable internet with Sky and we have 2 Cable routers (One for internet and one seems to be dedicated for the sky) and a 3rd WiFi router. Nice and simple.

I've never checked timing, I have new VANOS seals sitting around to be done at some stage however, It is abit down on power in the lower RPM than what I would expect then from 4000+ pulls hard, Probably a combination of M50 manifold + bad VANOS seals.

My M52B28 is running abit rich at times, especially when engine is cold, can see it is spitting unburnt fuel sometimes and when decelerating it is backfiring when warm. Had it scanned a while back and it came up with an 02 sensor fault about heating (forgot exactly), But I have since replaced MAF and new bosch O2 sensors, Seems to run alot better now but it is still running a tad rich. Have also replaced the coils but they made no difference, also had new spark plugs when it was put into my e30. Idle is fine, it never runs rough or stalls. Probably the M50 Manifold? I have a new air filter and intake to sort out, since I am using a crappy old setup. But any ideas on what else can cause this? I think I will need to hunt for vacuum leaks but I have all new gaskets / hoses throughout the intake.

I've been without internet for a month, Because apparently it takes Vodafone 1 month to hook up Cable. Homos. Worst customer service I have ever dealt with, Only went with them because we wanted Cable. Hopefully hooked up this afternoon finally.

It ain't an e30 24v swap if it doesn't have reliability issues ha.

pm Ando he has one

Bump

Anyone got a 80/88 temp sensor switch for e36 radiator? P/N 61 31 8 361 787

I think I saw that vert on Sunday night in Lyall bay. Looked alright