skidz

As per title, need a full set if ignition leads off facelift 325i, must be in excellent condition.

have one, $25

give me a call tonight, 021 744 881, have several

One of my favourite sites (OK, other than BS) is www.bringatrailer.com Check it out - on offer today is not only a standard CSL, but a genuine Alpina race car from 1974 also. Man, I would love one of these! But then, dreams are free at this time of year...

Can do a 3.73 LSD, medium case, good condition, $850 plus freight

It is certainly possible to do, and the best way is to get hold of a dead 1.3 325 or 320 engine as you need to swap just about everything that the loom attaches to - all the connections are different. So even things like water header tank level switch, oil level sensor, etc etc...

So, you sold the 2002 and the E9 coupe??? The garage must be bare now!

Actually, i liked the link in the story to the home built Lamborghini. Now that is one keen dude!

Can do flywheel, clutch, driveshaft, clutch pedal, give me a call, 021 744 881 Sunday would be best Cheers...Stephen

Yeah, but he is not telling anyone about it, supposed to be a secret...

I still reckon you are going to need the 325 pistons to match your 325 head, for your 2.7 build. The best way to do it it to use the 325 block, pistons, and head, and use your 2.7 crank and rods. There is a sticky on the technical forum here somewhere. Using the 2.7 pistons with the 325 head may not give you the results you are expecting.

Chewing gum, wrigleys juicy fruit works best, ask me how I know...

Give me a call, can do most this stuff, will get a wheel for you, 021 744 881 Cheers...Stephen

Most likely the channel at the rear of the sunroof, (it is like a gutter that channels the water across to the sides of the car) was not connected when they put the sun roof back in.

Got a real nice one, metalflake over matt black.....

Umm you need to give us more info, like Diff ratio Rear end - disc or drum? Part number for the OBC - they are all different, and match the engine...

Who did the computer remap for you?

Can do a complete conversion kit for $600,, there is a sticky for the swap.

Guys, I need the following: Oil level sensor and connections, that goes on top of the sump (on the passenger side). Facelift 320 motor has the same part Fan shroud, for a NZ new 325 manual, non-aircon car. The radiator is square rather than oblong. (and so is the shroud). PM me if you can help.

Was stolen from outside some guy's house and found down a bank. I thought these cars would have needed a key to overcome the immobiliser?

Can do 3.46 ratio, $750

Why dont you just buy a complete engine? And rebuild that?

The guy to see is Miles Udy in the Hutt, Miles Udy Motors.

Just buy it, Martyn...

PM me your address and I will send you a couple of spare rockers (I presume this is an M20 motor)?