thorburn

Depends on the condition of the bilsteins and the motorsport shocks. If you want to know you'll need to get them on a shock dyno (not sure if this is the proper name). You could get the bilsteins rebuilt to whatever spec you'd like while you are at it. The offset strut tops will add or decrease camber and caster. Do you have any photos of the strut tops?

you'll need to get a compression and leakdown test to get any idea of the health of your engine.

Bump cause it needs to go

one belt goes to ac from smaller part of crank pulley other belt goes around everything else you'll have to get a smaller than stock belt if your deleting the power steering

'lightweight-izing'

My guess is that you will get a result like this:(it might be an e36 but it has basically the same setup as you will have) You might be able to correct this with camber plates and some modification to where the strut mounts to the spindle. I hope you can get this to work though.

And you are going to have massive camber

Yes I was refering to putting e46 control arms into an e30 Aren't e30 lollypops 60mm. If not i was using it as an example of how to get around grinding the control arm. Which I guess would be the only illegal part of this. sorry op if this is off topic but I am assuming this is what you are doing

Glenn would you be able to explain why this would be illegal? if you didn't angle grind it down and used these http://www.turnermotorsport.com/html/detai...ID=31126757623D. And got rid of some camber with camber plates i'd guess there wouldn't be a problem with it getting a cert

Dimensions: http://www.brembo.com/CatalogoHPGT/DetailP...ni/09558520.pdf

It is about the height of the rotor is about 60mm. I'll get some accurate measurements when I find a ruler They might be able to be shimmed up to fit

Brembo calipers from Brembo GT kit that fit 320x28mm rotors Bolt straight on to e36 or 46 (not including m3's) Can fit under a 16' wheel Comes with old original cross drilled rotor, pads, calipers, and mounts http://www.brembo.com/CatalogoHPGT/DetailP...&idLingua=1 http://www.trademe.co.nz/Browse/Listing.as...751&ed=true Schnitzer type 1 wheels 16x8 et35 5x120 Tyres are yokohama 205/55 DNA Grandprix. All have not a lot of tread http://www.trademe.co.nz/Browse/Listing.as...067&ed=true

out of intrest would you mind sharing what it was? unplugged sensor of some sort?

These are two piece if they are genuine. Which they do seem to be You could remove about 10mm of offset and add some lip by mounting the face to the back. Here is a better description http://www.bespokeventures.com/blog/tag/bbs/

I've got one you can borrow

will the lip not reflect light into it? I like it

george stocks or autolign for coilover sleeves good to see you getting the footwork done before the power

what is your rev limiter set to now? this engine will make smiles

http://www.pelicanparts.com/cgi-bin/smart/...bearings%20only I'll just need to double check that I haven't already sorted one. I will get back to you tonight

is that an open diff behind all that power?

vaders weigh about 30kgs

Received mine this morning. Looks like a very tidy piece of kit Thank you M5V8 for organizing this

only applies to 328's. Not really going to make you look any better offset and height seems to be the look of most of the favourite e36 thread

m54

Could we add some sort of scale to this. Like I did this mod and I got laid this many times